Optimal Sensor Placement for High Pressure and Low Pressure EGR Estimation
نویسندگان
چکیده
منابع مشابه
Simultaneous Air Fraction and Low-Pressure EGR Mass Flow Rate Estimation for Diesel Engines
This paper describes a low-pressure exhaust gas recirculation (LP-EGR) mass flow rate estimation method and a robust air mass fraction observer for a Diesel engine with dualloop EGR system. Both observers operate simultaneously eliminating the need for pressure measurement upstream the LP-EGR valve. A sliding mode observer is designed to estimate the LP-EGR mass flow rate using the standard sen...
متن کاملDesign and Application of a High Sensitivity Piezoresistive Pressure Sensor for Low Pressure Conditions
In this paper, a pressure sensor for low pressure detection (0.5 kPa-40 kPa) is proposed. In one structure (No. 1), the silicon membrane is partly etched to form a crossed beam on its top for stress concentration. An aluminum layer is also deposited as part of the beam. Four piezoresistors are fabricated. Two are located at the two ends of the beam. The other two are located at the membrane per...
متن کاملHigh-volume, low-pressure cuffs. Are they always low pressure?
Ischemic tracheal complications due to the ETT cuff occur in approximately 10 percent of mechanically ventilated critically ill patients despite the use of high-volume, low-pressure ETT cuffs. Using a laboratory model, we studied the effects of airway pressure on three different ETT cuff designs, including two "low pressure" designs. Positive airway pressure acted on the "low pressure" cuffs to...
متن کاملA Wireless and Passive Low-Pressure Sensor
This paper will discuss the results obtained with a first prototype of a completely passive and wireless low pressure sensor. The device is a heat conductivity gauge, based on a wireless and passive SAW temperature sensor. The required heating energy is applied to the sensor using inductive coupling. The prototype was successfully tested in a vacuum chamber. Its equilibrium temperature changed ...
متن کاملDesign of High Sensitivity and Linearity Microelectromechanical Systems Capacitive Tire Pressure Sensor using Stepped Membrane
This paper is focused on a novel design of stepped diaphragm for MEMS capacitive pressure sensor used in tire pressure monitoring system. The structure of sensor diaphragm plays a key role for determining the sensitivity of the sensor and the non-linearity of the output.First the structures of two capacitive pressure sensors with clamped square flatdiaphragms, with different thicknesses are inv...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: SAE technical paper series
سال: 2021
ISSN: ['1083-4958', '0148-7191']
DOI: https://doi.org/10.4271/2021-01-0423