Optimal polymer slugs injection profiles
نویسندگان
چکیده
The graded viscosity banks technology (tapering) for polymer flooding is studied several different models of mixing zones behavior. Depending on the function limiting injection profile rigorously derived transverse flow equilibrium model, Koval model and Todd-Longstaff model. potential gain in quantity compared to with a finite number slugs numerically estimated.
منابع مشابه
Drops, Slugs, and Flooding in Polymer Electrolyte Membrane Fuel Cells
The process of flooding has been examined with a single-channel fuel cell that permits direct observation of liquid water motion and local current density. As product water flows through the largest pores in the hydrophobic GDL, drops detach from the surface, aggregate, and form slugs. Flooding in polymer electrolyte membrane (PEM) fuel cells occurs when liquid water slugs accumulate in the gas...
متن کاملPredicting injection profiles using ANFIS
Decision making pertaining to injection profiles during oilfield development is one of the most important factors that affect the oilfields’ performance. Since injection profiles are affected by multiple geological and development factors, it is difficult to model their complicated, non-linear relationships using conventional approaches. In this paper, two adaptivenetwork-based fuzzy inference ...
متن کاملContact Injection into Polymer Light-Emitting Diodes
The variation of current I with voltage V for poly(phenylene vinylene) and other polymer light-emitting diodes has been attributed to carriers tunneling into broad conduction and valence bands. In actuality the electrons and holes tunnel into polaron levels and transport is by hopping among these levels. We show that for small injection the I-V characteristic is determined mainly by the image f...
متن کاملImage Analysis Dedicated to Polymer Injection Molding
This work follows the general framework of polymer injection moulding simulation whose objectives are the mastering of the injection moulding process. The models of numerical simulation make it possible to predict the propagation of the molten polymer during the filling phase from the positioning of one point of injection or more. The objective of this paper is to propose a particular way to op...
متن کاملMicro-Injection Moulding of Polymer Microfluidic Devices
* Building 56, Cranfield University, Wharley End, Cranfield, Bedfordshire, MK43 0AL, UK. Tel: +44 (0)1234 750111 ext: 2513; E-mail: [email protected] a Building 56, Cranfield University, Wharley End, Cranfield, Bedfordshire, MK43 0AL, UK. Fax: +44 (0)1234 751346; Tel: +44 (0)1234 750111 ext: 2379; E-mail: [email protected] b Building 61, Cranfield University, Wharley End, Cranfield...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Computational and Applied Mathematics
سال: 2023
ISSN: ['0377-0427', '1879-1778', '0771-050X']
DOI: https://doi.org/10.1016/j.cam.2022.115042