Optimal Cutting Condition and Maximal Tool Force in Circular Rock Cutting. Study on disc cutting of rock. (2nd Report).
نویسندگان
چکیده
منابع مشابه
Evaluation of Disc Cutter Performance in Rock Cutting Process Using 3D Finite Element Method
Today, numerical simulation can be used as a suitable tool to measure large quantities that are very expensive and, in some cases, impossible to measure. One of the important issues in predicting rock mass boreability in excavation with full face tunnel boring machines is estimating the discchr('39')s forces for rock cutting. For this purpose, the linear cutting test is employed. However, limi...
متن کاملThe Impact of Cutting Tool Materials on Cutting Force
A judicious choice of insert material, tool geometry and cutting conditions can make hard turning produce better surfaces than grinding. In the present study, an attempt has been made to investigate the effect of cutting tool materials on cutting forces (feed force, thrust force and cutting force) in finish hard turning of AISI D2 cold work tool steel. In conclusion of the results obtained with...
متن کاملEffects of Friction and Cutting Speed on Cutting Force
Observations are made regarding the influence of cutting speed and friction on cutting force by way of finite element modeling. Simulations are validated by comparison of cutting forces and chip morphologies for the Al6061-T6. Analysis of cutting forces over a wide range of cutting conditions suggests an important role of the secondary shear zone in the decrease of cutting force as a function o...
متن کاملCombining fuzzy RES with GA for predicting wear performance of circular diamond saw in hard rock cutting process
Predicting the wear performance of circular diamond saw in the process of sawing hard dimensional stone is an important step in reducing production costs in the stone sawing industry. In the present research work, the effective parameters on circular diamond saw wear are defined, and then the weight of each parameter is determined through adopting a fuzzy rock engineering system (Fuzzy RES) bas...
متن کاملCutting-Tool Materials and Cutting Fluids
The reasons for the availability of a large variety of cutting-tool materials is best appreciated by reviewing the top eight parameters in the first column in Table 22.2 on p. 638. Among various factors, the type of workpiece material machined, the type of operation, and the surface finish and dimensional accuracy required all affect the choice of a cutting-tool material. For example, for inter...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Shigen-to-Sozai
سال: 1992
ISSN: 0916-1740,1880-6244
DOI: 10.2473/shigentosozai.108.849