ON THK BEHAVIOUR OF HARDNESS-CURVE OF QUENCHED STEELS (II)
نویسندگان
چکیده
منابع مشابه
effect of oral presentation on development of l2 learners grammar
this experimental study has been conducted to test the effect of oral presentation on the development of l2 learners grammar. but this oral presentation is not merely a deductive instruction of grammatical points, in this presentation two hypotheses of krashen (input and low filter hypotheses), stevicks viewpoints on grammar explanation and correction and widdowsons opinion on limited use of l1...
15 صفحه اولComparison of Hardness and Wear Behaviour of Boronized and Carburized AISI 8620 Steels
In this study, the hardness and wear behaviour of carburized and boronized AISI 8620 steels have been studied. The boronizing treatment increased the hardness of AISI 8620 steels from 395 HV0.1 to a maximal 1610 HV0.1 compared to the carburized steels and also significantly improved its wear behaviour. From obtained results, it can be concluded that boronizing is very effective surface hardenin...
متن کاملthe effect of explicit teaching of metacognitive vocabulary learning strategies on recall and retention of idioms
چکیده ندارد.
15 صفحه اولthe effect of consciousness raising of sociolinguistic skills on speaking ability of iranian efl learners
abstract the main purpose of this study was to investigate whether there was any significant difference between the speaking achievement of learners who were trained by means of consciousness raising of sociolinguistic skills and that of learners who were trained without the above mentioned task. the participants of this study consist of 60 intermediate level students participating languag...
Evaluation of corrosion behaviour on Mn-Cr austenitic steels using 0.1 M HCl solution
One of the attractive low activation steels is the austenitic Mn-Cr steel from the view point of waste disposal because of few long-lived nuclides. In this paper, three types of Mn-Cr austenitic steels were fabricated by vacuum induction furnace. Then plates with 10 mm thickness were fabricated by hot-rolling. The physical metallurgy of these steels was studied by the corrected Schaeffler diagr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 1951
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1915.37.4_212