On Thermal Characteristics in Cutting Rocks by Thermodrill
نویسندگان
چکیده
منابع مشابه
suppression of coke formation in thermal cracking by coke inhibitors
the main purpose of this research was to:1.develop a coking model for thermal cracking of naphtha.2.study coke inhibition methods using different coke inhibitors.developing a coking model in naphtha cracking reactors requires a suitable model of the thermal cracking reactor based on a reliable kinetic model.to obtain reliable results all these models shall be solved simultaneously.for this pu...
15 صفحه اولPrototype of Cutting Machine by Wire-sawing in Vacuum for In-situ Investigation of Rocks
Introduction: A bullet type sampler is sometimes used to obtain a sample from an asteroid on samplereturn missions [1]. On the other hand, in-situ analysis is demanded for the investigation of more amount of rock samples. Many drilling or coring devices have been developed [2-5]. Slicing the rock sample is preferable to observe its interior rather than shaving [6]. Because coolant cannot use in...
متن کاملPredicting Thermal Conductivity of Rocks From
A correlation is developed to predict thermal conductivity of drill cores from the L o s Azufres geothermal field. Only andesites are included as they are predominant. Thermal conductivity of geothermal rocks is in general scarce and its determination is not simple. Almost all published correlations were developed for sedimentary rocks. Typically, for igneous rocks, chemical or mineral analyses...
متن کاملLASER CUTTING PARAMETERS The laser cutting parameters are dependent on the beam characteristics, the cutting rate
The laser cutting parameters are dependent on the beam characteristics, the cutting rate required, the composition and thickness of the material to be cut, and the desired cut edge quality. The laser cutting process and cut quality depend upon the proper selection of laser and workpiece parameters. Deficiencies in cutting quality may be related to the slow process drifts and disturbances that a...
متن کاملExperimental Investigation on Cutting Characteristics in Nanometric Plunge-Cutting of BK7 and Fused Silica Glasses
Ductile cutting are most widely used in fabricating high-quality optical glass components to achieve crack-free surfaces. For ultra-precision machining of brittle glass materials, critical undeformed chip thickness (CUCT) commonly plays a pivotal role in determining the transition point from ductile cutting to brittle cutting. In this research, cutting characteristics in nanometric cutting of B...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Mining and Metallurgical Institute of Japan
سال: 1976
ISSN: 0369-4194,2185-6729
DOI: 10.2473/shigentosozai1953.92.1062_531