On the Wire Drawing Lubricant
نویسندگان
چکیده
منابع مشابه
Lawd – Laser Assisted Wire Drawing
In conventional wire drawing the diameter of a wire or rod-like workpiece is reduced by drawing it through a conical die. Dieless drawing of a wire or a rod is realized by a localized heating of the work piece. As heat source for example an induction coil can be used. Immediately after having passed the heating zone the work piece is cooled to restrict the heat input on very small region. By ap...
متن کاملInfluence of an Inclusion on Multi-Pass Copper Shaped-Wire Drawing by 2D Finite Element Analysis
The size and length effects of an inclusion on multi-pass copper shaped-wire drawing were investigated. For this purpose, an experimental investigation on optimal die half-angle was conducted. Based on experimental data of optimal die half-angle, wire and inclusion deformations, drawing and hydrostatic stress of copper shaped-wires that contain an inclusion were calculated by two-dimensional fi...
متن کاملAdvances in wire drawing process by theoretical and numerical analysis
Ductile metal deformation processes aimed at production of wire of some sort are in use since over five thousand years, early ones dating back to the origins of copper and gold produc tion. Thin sheets, initially produced by hammering, were cut into thin strips suitable for ornamental pur poses. The introduction of die plate paved the way to round wire manufac turing, rather severe limitatio...
متن کاملNiobium-Titanium Superconducting Wires: Nanostructures by Extrusion and Wire Drawing
Nano-fabrication is not new to the manufacturers of superconducting wires, in fact the dominant commercial superconductor, Nb-Ti, relies on a mechanically induced nano-structure for its remarkable properties. In this paper we show how these wires are manufactured so that their microstructure achieves the same scale as the superconducting vortex spacing. Recent attention on superconductors has e...
متن کاملDeveloping Very Fine Nanopearlitic Structure in a High Carbon Steel Wire before Drawing
The effects of steel wire patenting process parameters on very fine interlamellar spacing in the pearlitic steel wire were investigated and the optimized condition of the process was achieved. In this work, the initial nanopearlitic structure was obtained in a 0.72 wt% carbon steel wire before the wire drawing process. The results were the minimum interlamellar spacing of 35 nm and maximum ulti...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Society of Mechanical Engineers
سال: 1961
ISSN: 0029-0270,2185-9485
DOI: 10.1299/kikai1938.27.1439