On the Vickers hardness
نویسندگان
چکیده
منابع مشابه
Low-Load Vickers Microindentation Hardness Testing
ADVANCED MATERIALS & PROCESSES • APRIL 2012 I n 1925 in the UK, Smith and Sandland developed an indentation test that used a squarebased pyramidal-shaped indenter made of diamond[1]. The test was developed because the Brinell test (introduced in 1900), which (until recently) used a round hardened steel ball indenter, could not test steels harder than ~450 HB (~48 HRC). They chose this shape wit...
متن کاملInfluence of the shaping effect on hardness homogeneity by Vickers indentation analysis
Influence of the shaping effect on hardness homogeneity by Vickers indentation analysis B. Guillaume a,∗, F. Boschini a, A. Rulmont a, M. Ausloos b, R. Cloots a a Laboratoire de Chimie Inorganique Structurale, SUPRATECS, Department of Chemistry, Chemistry Inst. B6, University of Liège, Sart-Tilman, B-4000 Liège, Belgium b Physique Statistique et des Matériaux, SUPRATECS, Department of Physics, ...
متن کاملEffect of Post-polymerization Treatments on the Flexural Strength and Vickers Hardness of Reline and Acrylic Denture Base Resins
This study evaluated the effect of water-bath and microwave post-polymerization treatments on the flexural strength and Vickers hardness of four autopolymerizing reline resins (Duraliner II-D, Kooliner-K, Tokuso Rebase Fast-TR and Ufi Gel Hard C-UGH) and one heat-polymerized acrylic resin (Lucitone 550-L), processed using two polymerization cycles (short cycle - 90 minutes at 73 degrees C and 1...
متن کاملComparative Depth of Cure Among Two Light-Cured Core Build-Up Composites By Surface Vickers Hardness
OBJECTIVE Depth of cure of composite material is restricted and it depends on many parameters such as thickness. The aim of this in-vitro study was to evaluate the depth of cure of two light-cured core build-up composites (Quixfil and Photocore) in different thicknesses, when cured for 60 seconds. MATERIALS AND METHODS The Vickers microhardness measurements were made for each side of the top ...
متن کاملVickers hardness and Specific wear resistance of E glass reinforced poly methyl methacrylate
Poly methyl methacrylate (PMMA) is one of the most widely accepted biomaterial in prosthetic dentistry due to its acceptable advantages. However the conventional PMMA used are far from being ideal because of their inferior mechanical properties. So the present study is to determine the Vickers Hardness and specific wear rate of the silane treated E glass fiber reinforced PMMA. Vickers Hardness ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Society of Mechanical Engineers
سال: 1941
ISSN: 0029-0270,2185-9485
DOI: 10.1299/kikai1938.7.27-1_26