On the Vibration of Workpiece during Grinding
نویسندگان
چکیده
منابع مشابه
the effect of e-64 on the developmental competence of sheep cocs during in vitro maturation
in the present study, the effect of e-64 at different concentrations (0.5, 1, 5 and 10 µm) added to (1) the ivm medium on oocyte nuclear maturation and developmental competence of ovine oocytes, and (2) to the ivc medium on embryonic development of ovine embryos were investigated.
Temperature distribution in workpiece during scratching and grinding
The heat transfer problem of a moving heat source along the surface of a half space was studied analytically and numerically. For the 2D problem, the heat source was a strip moving source and for the 3D problem, the heat source was a square moving source. Analytical solutions are available only for adiabatic conditions as given by Carslaw and Jaeger [H.S. Carslaw, J.C. Jaeger, Conduction of Hea...
متن کاملTHE EFFECT OF GRINDING TIME ON THE SPECIFIC SURFACE AREA DURING INTENSIVE GRINDING OF MINERAL POWDERS
Abstract: the changes of BET surface area of a mineral substance during intensive grinding process. Validity of the proposedmodel was tested by the experiments performed using a natural chalcopyrite mineral as well as the published data. Itwas shown that the model can predict the experimental results with a very good accuracy and can be used to predictwhat may happen under the similar experimen...
متن کاملEffect of low-frequency vibration on workpiece in EDM processes
High-frequency vibration aided EDM has become one of the ways to increase material removal rate in EDM process, due to the flushing effect caused by vibration. However, utilizing high-frequency vibration, especially in ultrasonic range consumes a lot of setup cost. This work presents an attempt to use a low-frequency vibration on workpiece of stainless steel (SS 304) during EDM process. The wor...
متن کاملVariability in hand-arm vibration during grinding operations.
BACKGROUND Measurements of exposure to vibrations from hand-held tools are often conducted on a single occasion. However, repeated measurements may be crucial for estimating the actual dose with good precision. In addition, knowledge of determinants of exposure could be used to improve working conditions. The aim of this study was to assess hand-arm vibration (HAV) exposure during different gri...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Precision Engineering
سال: 1974
ISSN: 0374-3543
DOI: 10.2493/jjspe1933.40.1073