On the Machinability for Alumina Green Compact. (Part 6). Cutting Force on Orthogonal Cutting.
نویسندگان
چکیده
منابع مشابه
Machinability evaluation of titanium alloys (Part 2)--Analyses of cutting force and spindle motor current.
To establish a method of determining the machinability of dental materials for CAD/CAM systems, the machinability of titanium, two titanium alloys (Ti-6Al-4V and Ti-6Al-7Nb), and free-cutting brass was evaluated through cutting force and spindle motor current. The metals were slotted using a milling machine and square end mills at four cutting conditions. Both the static and dynamic components ...
متن کاملThe Impact of Cutting Tool Materials on Cutting Force
A judicious choice of insert material, tool geometry and cutting conditions can make hard turning produce better surfaces than grinding. In the present study, an attempt has been made to investigate the effect of cutting tool materials on cutting forces (feed force, thrust force and cutting force) in finish hard turning of AISI D2 cold work tool steel. In conclusion of the results obtained with...
متن کاملEffects of Friction and Cutting Speed on Cutting Force
Observations are made regarding the influence of cutting speed and friction on cutting force by way of finite element modeling. Simulations are validated by comparison of cutting forces and chip morphologies for the Al6061-T6. Analysis of cutting forces over a wide range of cutting conditions suggests an important role of the secondary shear zone in the decrease of cutting force as a function o...
متن کاملAssessment of Machinability of Metal Cutting
The assessments of machinability of metal cutting are called "indices" and are derived by comparative research. These indices are the relations of two identical parameters, such as is the allowable cutting speed. The assessments were obtained at a constant tool life of 60 min, at the appropriate tool life minimum costs and the efficient reporting of specific restrictions for finishing and rough...
متن کاملA Methodology for Practical Cutting Force Evaluation Based on the Energy Spent in the Cutting System
& This paper presents a methodology for practical estimation of cutting force and cutting power. Based on a previously proposed definition, the power spent in metal cutting is the summation of four components: the power spent on the plastic deformation of the layer being removed by both major and minor cutting edges, the power spent on the tool-chip interface, the power spent on the tool-workpi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 1999
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.46.417