ON SOME HIGH SPEED STEELS AND CHIPPED TOOLS

Secondary Hardening in High Speed Steels

Carbide Structure and Fracture Toughness of High Speed Tool Steels

In the present study, M2 high speed steels were fabricated by using electro-slag rapid remelting process. Carbide structure was analysed and the fracture toughness and hardness were also measured after austenitization treatment at 1190 and 1210C followed by tempering treatment at 535C for billets with various diameters from 16 to 60 mm. Electro-slag rapid remelting (ESRR) process is an advanced...

High-Strength Bainitic Steels

With careful design, mixed microstructures consisting of fine plates of upper bainitic ferrite separated by thin films of stable retained austenite have exhibited impressive combinations of strength and toughness in highsilicon bainitic steels. The silicon suppresses the precipitation of brittle cementite leading to an improvement in toughness. The essential principles governing the optimisatio...

the effect of tools length on stable materials removal rate in high speed milling process

0

Some phase transformations in steels

About 70% of all the steel compositions that are currently used have been developed within the last 10 years. Novel iron alloys are being conceived, manufactured, and marketed with a regularity which has confounded many prophecies. Phase transformation theory has contributed to the successful development of steels. This overview will begin therefore with a discussion of the atomic mechanism by ...