On Mechanical Properties of the Tufftrided Low Carbon Steel
نویسندگان
چکیده
منابع مشابه
Enhancement of mechanical properties of low carbon steel based on heat treatment and thermo-mechanical processing routes
Thermal treatments and thermo-mechanical processing routes were applied on a conventional structural steel (st37 steel: 0.12C-1.11Mn-0.16Si) for improvement of tensile properties and enhancement of work-hardening behavior. Full annealing resulted in a sheet with coarse ferrite grains and pearlite colonies arranged alternatively in distinct bands, which showed high ductility, low strength, and t...
متن کاملEffect of Ti-microalloy Addition on the Formability and Mechanical Properties of a Low Carbon (ST14) Steel
A low carbon Al-killed Ti-added steel was produced in Mobarakeh Steel Complex in Iran. Mechanical properties and microstructural characterizations of steel in the as-cast, hot-rolled, cold-rolled and annealed conditions are presented. Dilatometery tests were carried out to measure the finishing and annealing temperatures of steel. It was found that the addition of small amounts of Ti increas...
متن کاملmodification of nanoclay for improving the physico-mechanical properties of dental adhesives
هدف اصلی این مطالعه تهیه یک سامانه نوین چسب عاجی دندانی بر پایه نانورس پیوند شده با پلی متاکریلیک اسید، نانورس پیوند شده با پلی اکریلیک اسید، مخلوط نانوسیلیکا و نانورس پیوند شده با پلی متاکریلیک اسید، مخلوط نانوسیلیکا و نانورس پیوند شده با پلی اکریلیک اسید و نانورس پیوند شده با کیتوسان اصلاح شده با گلایسیدیل متاکریلات است. پیوند پلی متاکریلیک اسید و پلی اکریلیک اسید بر ری سطح نانورس در حضور و ...
investigation of the electronic properties of carbon and iii-v nanotubes
boron nitride semiconducting zigzag swcnt, $b_{cb}$$n_{cn}$$c_{1-cb-cn}$, as a potential candidate for making nanoelectronic devices was examined. in contrast to the previous dft calculations, wherein just one boron and nitrogen doping configuration have been considered, here for the average over all possible configurations, density of states (dos) was calculated in terms of boron and nitrogen ...
15 صفحه اولeffect of ti-microalloy addition on the formability and mechanical properties of a low carbon (st14) steel
a low carbon al-killed ti-added steel was produced in mobarakeh steel complex in iran. mechanical properties and microstructural characterizations of steel in the as-cast, hot-rolled, cold-rolled and annealed conditions are presented. dilatometery tests were carried out to measure the finishing and annealing temperatures of steel. it was found that the addition of small amounts of ti increased ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 1966
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet1952.30.3_290