On fitting position of inlet and outlet pipes to elliptic cylindrical muffler chambers.
نویسندگان
چکیده
منابع مشابه
Three-Dimensional Acoustic Analysis of an Elliptical Chamber Muffler with a Side Inlet and a Side Outlet
*Fellow of the International Institute of Acoustics and Vibration, Author for correspondence: Email address: [email protected] 1 Three-Dimensional Acoustic Analysis of an Elliptical Chamber Muffler with a Side Inlet and a Side Outlet A. Mimani and M.L. Munjal* Facility for Research in Technical Acoustics (FRITA), Department of Mechanical Engineering, Indian Institute of Science, Ba...
متن کاملThe optimization of inlet and outlet port locations of a vented square cavity
In this study, mixed convection heat transfer and local and global entropy generation in aventilated square cavity have been investigated numerically. The natural convection effect isachieved by a constant heat flux imposed at the bottom wall and cooled by injecting a coldfollow. In order to investigate the effect of port location, four different placementconfigurations of the inlet and outlet ...
متن کاملInlet and outlet devices for rotary blood pumps.
The purposes of inlet and outlet devices for rotary blood pumps, including inducers and diffusers for axial pumps, inlet and exit volutes for centrifugal pumps, and inlet and outlet cannulas, are to guide the blood into the impeller, where the blood is accelerated, and to convert the high kinetic energy into pressure after the impeller discharge, respectively. The designs of the inlet and outle...
متن کاملA Vertex Trigger based on Cylindrical Multiwire Proportional Chambers
This article describes the technical implementation and the performance of the zvertex trigger (CIP2k), which is part of the H1-experiment at HERA. The HERA storage ring and collider was designed to investigate electron (and positron) proton scattering at a center-of-mass energy of 320 GeV. To improve the sensitivity for detecting non-standard model physics and other high momentum transfer phen...
متن کاملInvestigation of the Flow Characteristics in a Catalytic Muffler with Perforated Inlet Cone
Emission regulations for diesel engines are being strengthened and it is impossible to meet the standards without exhaust after-treatment systems. Lack of the space in many diesel vehicles, however, make it difficult to design and install stand-alone catalytic converters such as DOC, DPF, and SCR in the vehicle exhaust systems. Accordingly, those have been installed inside the muffler to save t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Acoustical Society of Japan (E)
سال: 1981
ISSN: 0388-2861,2185-3509
DOI: 10.1250/ast.2.71