منابع مشابه
The effect of spring restraint on weld distortion in t-joint fillet welds
T-joint fillet welds are a very common occurrence found in industry today. Localized heating and cooling from the welding process lead to the rise of distortion and residual stresses. Weld fixturing is a common practice in industry used to address the problems associated with welding, however fixturing also creates problems of residual stresses being locked into the weldment. This research invo...
متن کاملExperimental Study on Strength and Ductility of Underwater Fillet Welds in Repairing Offshore Steel Structures
Underwater wet welding is one of the most common repair measures for corroded offshore steel structures. Few studies have been carried out systematically concerned with mechanical properties of such welds, thus current design provisions rely heavily on limited experimental data on welds made underwater and design properties for corresponding welds made in air. This paper presents a series of ex...
متن کاملWelding Gun Inclination Detection and Curved Fillet Weld Joint Tracking
It is important to adjust the welding gun's inclination during automatic curved-joint tracking of arc welding. In this paper, a novel method is proposed to detect the deviation and inclination of the welding gun based on the arc currents acquired by a high-speed rotational arc sensor. It uses a least-squares method to fit the arc currents to a plane in three dimensions. The deviation and inclin...
متن کاملon semihypergroups and hypergroups
in this thesis, first the notion of weak mutual associativity (w.m.a.) and the necessary and sufficient condition for a $(l,gamma)$-associated hypersemigroup $(h, ast)$ derived from some family of $lesssim$-preordered semigroups to be a hypergroup, are given. second, by proving the fact that the concrete categories, semihypergroups and hypergroups have not free objects we will introduce t...
15 صفحه اولStrong Ferritic – Steel Welds
There are many steels which are stronger than 2000 MPa, with toughness values exceeding 100 MPa m and which have been in commercial service for many decades. Examples include the marageing alloys and carbide–free bainitic steels. By contrast, welding consumables with a proof strength in excess of 1000 MPa are few and far between. This is because whereas wrought steels can be thermomechanically ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Institute of Japanese Architects
سال: 1938
ISSN: 0387-1169,2432-9991
DOI: 10.3130/aijsaxxxx.9.0_159