Ohmic contacts to Si-implanted and un-implanted n-type GaN

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Metastable Giant Moments in Gd-Implanted GaN, Si, and Sapphire

We report on Gd ion implantation and magnetic characterization of GaN films on sapphire substrates and of bare sapphire and Si substrates to shed light on the mechanism underlying the induced magnetism upon Gd ion implantation. For all three hosts, giant magnetic moments per Gd ion were observed at temperatures of 5 through 300 K. The maximum moment per Gd in GaN was 1800μB , while the moments ...

متن کامل

Nanoscale electro-structural characterisation of ohmic contacts formed on p-type implanted 4H-SiC

This work reports a nanoscale electro-structural characterisation of Ti/Al ohmic contacts formed on p-type Al-implanted silicon carbide (4H-SiC). The morphological and the electrical properties of the Al-implanted layer, annealed at 1700°C with or without a protective capping layer, and of the ohmic contacts were studied using atomic force microscopy [AFM], transmission line model measurements ...

متن کامل

Electrical, thermal, and microstructural characteristics of TiÕAlÕTiÕAu multilayer Ohmic contacts to n-type GaN

The electrical, thermal, and microstructural characteristics of Ti/Al/Ti/Au ~30 nm/100 nm/30 nm/30 nm! multilayer Ohmic contacts to n-GaN ~doping level 5310 cm) were studied. The lowest contact resistivity derived from the annealed contact was rS53.0310 V cm. The contacts were robust and showed high-thermal stability. X-ray diffraction and Auger electron spectroscopy studies were made to invest...

متن کامل

Blistering of H-implanted GaN

Mechanisms of blistering of wurtzite GaN films implanted with H ions are studied. In particular, we report on the influence of the following parameters on the blistering process: ~i! ion energy ~from 20 to 150 keV!, ~ii! ion dose ~up to 1.2310 cm!, ~iii! implantation temperature ~from 2196 to 250 °C!, and ~iv! annealing temperature ~up to 900 °C!. Results show that both the onset of blistering ...

متن کامل

Characterization of an Mg-implanted GaN p-i-n Diode

A p-i-n diode formed by the implantation of Mg in GaN was fabricated and characterized. After implantation, Mg was activated using the symmetrical multicycle rapid thermal annealing technique with heating pulses up to 1340C. The Mg-implanted p-i-n diode exhibits rectification and low leakage currents. The realization of an Mg-implanted GaN device is a key step for future power electronic devices.

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: MRS Proceedings

سال: 1995

ISSN: 0272-9172,1946-4274

DOI: 10.1557/proc-395-855