Numerical simulation of vertical mold casting temperature field of copper anode plates
نویسندگان
چکیده
منابع مشابه
The Effect of Dewaxing and Burnout Temperature in Block Mold Process for Copper Alloy Casting
The main objective of this research is to investigate the effect of dewaxing and burnout temperature on the quality of copper alloy casting produced by a low cost block mold that has been developed. In the molding process, two types of silica sand which contains 97.9% silica (SiO2) and 97.2% silica have been used as a refractory material with POP served as a binder. Several mold formulations co...
متن کاملA Numerical Simulation Study on Wellbore Temperature Field of Water Injection in Highly Deviated Wells
According to the temperature distribution of water injection well-bore in highly deviated wells under different conditions and unstable temperature field heat conduction principles, a true three-dimensional model was established to analyze the law of variation on temperature of highly deviated wells during the water injection process, and to analyze the factors that influence the water injectio...
متن کاملNumerical Simulation of the Investment Casting Process
Determining alloy shrinkage factors is very important for the investment casting process. Casting dimensions can be obtained from numerical simulations of heat transfer and deformation phenomena. The accuracy of the dimensional results depends on heat transfer results. In order to validate heat transfer models, temperature data were obtained during casting of aluminum alloy A356 in shell molds ...
متن کاملAnalyzing the Failure of Master Mould in Casting of Copper Anode Moulds and Suggesting a more Suitable Metal Mould
Master moulds are used to cast copper anode moulds. These iron moulds are made of grey or nodular cast irons. According to desirable properties of ductile irons, it was expected that ductile cast iron ...
متن کاملNumerical Simulation of Temperature Field in Selective Laser Sintering
The laser sintering process of multi-component powder W/Cu is simulated by ANSYS software based on the factors of radiation, convection and thermal physical parameters on temperature. The laser power and scanning velocity which are the key process parameters to affect directly in sintering molding are studied in paper. The results show that when the scanning velocity is constant, the sintering ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Engineering Research Express
سال: 2020
ISSN: 2631-8695
DOI: 10.1088/2631-8695/abbdce