Numerical Simulation of Ultrafine-grain Generation in Super Short Interval Multi-pass Rolling Process
نویسندگان
چکیده
منابع مشابه
Numerical Simulation in Roll Pass Design for Bar Rolling
S. A. Aksenov, E. N. Chumachenko, I. V. Logashina, Higher School of Economics, Department of Mechanics and Mathematical Simulation, Moscow, Russia T. Kubina, VŠB – Technical University of Ostrava, Faculty of Metallurgy and Materials Engineering, Ostrava, Czech Republic The application of finite element simulation to the problem of roll pass design for round bar rolling is considered. Two roll p...
متن کاملNUMERICAL SIMULATION OF RING ROLLING PROCESS FOR Ni-BASE ARTICLES
Continuous improvements of properties for individual parts are indispensable for perpetual development of aircraft engines. Concerning casing and seal, simulation of ring rolling process is one of the most attractive tools to reduce the cost and time and to improve the properties and the reliability at the same time. In order to obtain both practical prediction accuracy and acceptable computati...
متن کاملnumerical simulation of residual stress distribution in al alloy plate after a cold rolling process
0
متن کاملSimulation of Cold Rolling Process Using Smoothed Particle Hydrodynamics (SPH)
Regarding the reported capabilities and the simplifications of the smoothed particle hydrodynamics (SPH) method, as a mesh-free technique in numerical simulations of the deformation processes, a 2-D approach on cold rolling process was provided. Using and examining SPH on rolling process not only caused some minor developments on SPH techniques but revealed some physical realities. The chosen t...
متن کاملInvestigation and Simulation of Wire Non-Asymmetric Rolling Process
The non-asymmetric rolling process of copper and brass wire has been simulated with the Abaqus software. Presented finite element model in this simulation of rolling predicted output curvature and contact surface width in the non-asymmetric mode (in equality of diameter of rollers, the rotational speed of the rollers and the rollers’ surface finish). The material used in this research has strai...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Technology of Plasticity
سال: 2013
ISSN: 0038-1586,1882-0166
DOI: 10.9773/sosei.54.148