Numerical simulation of seepage maps under dams with sheet piles on their ends
نویسندگان
چکیده
منابع مشابه
Numerical computation of seepage erosion below dams (piping)
In delta areas the land is protected from floods and high tides by dikes. In general these are constructed of impervious clays and built on a sandy aquifer as subsoil. Such structures are vulnerable to an erosion effect called piping. The actual word 'piping' refers to the development of shallow channels in the sand below the dike, which begins at the downstream side of the structure. Here ofte...
متن کاملA Numerical Study for the Simplification of Large Scenarios of Seepage under Dams
The seepage flow under concrete dams, besides its dependence on soil permeability and the different total head upstream and downstream, is strongly determined by the geometry of the scenario. However, there are limits in the length and depth of the ground for which the quantity of seepage converges to a maximum value. These limits values, which are not independent, separate two types of scenari...
متن کاملNumerical Simulation of Free Seepage Flow on Non-matching Grids
A new domain decomposition technique on non-matching grids for free boundary problems is considered. An iterative DD scheme is used to reduce the original free boundary problem to a sequence of problems on two sub-domains, one of which includes the free boundary and is described by a variational inequality and the other includes the remainder of the problem and is described by a second order pa...
متن کاملNumerical Simulation of Piles Subjected To Lateral Spreading and Comparison with Shaking Table Results
Pile foundations are relatively vulnerable to lateral loads. During liquefaction-induced lateral spreading, this vulnerability is particularly conspicuous due to a loss of strength and stiffness in the liquefied soil. A nonlinear effective stress analysis incorporating an elastoplastic constitutive model based on Finite Difference Method (FLAC2D program) was used to numerically simulate shake t...
متن کاملNumerical simulation of laser beam welding of Ti6Al4V sheet
This paper was aimed to report the 3D finite element analysis simulation of laser welding process of Ti6Al4V 1.7 mm sheets in butt joint in order to predict the temperature distribution, hardness, and weld geometry. The butt-joint welds were made using CO2 laser with the maximum power of 2.2 kW in the continuous wave mode. A part of the experimental work was carried out to verify the weld geome...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Computational and Mathematical Methods
سال: 2019
ISSN: 2577-7408
DOI: 10.1002/cmm4.1010