Numerical simulation of rotating stall in a two-stage axial fan
نویسندگان
چکیده
منابع مشابه
Numerical Investigation of Rotating-Stall in a Stage of an Axial Compressor with Two Different Approaches
An unsteady two-dimensional finite-volume solver was developed based on Van Leer’s flux splitting algorithm in conjunction with “Monotonic Upstream Scheme for Conservation Laws (MUSCL)” limiters and the two-layer Baldwin-Lomax turbulence model was also implemented. To validate the solver, two test cases were prepared and the computed results had good agreements with reference data. The rotating...
متن کاملRotating Stall in Axial Flow Compressors
Ever increasing demand of higher pressure ratio of aero-engine compressors has always been hindered by two distinct aerodynamic instabilities. The first known as surge is; large one dimensional periodic mass flow fluctuation through the compressor, which involves the entire pumping system including compressor, ducting, plenum and throttle. The second is the rotating stall which can be character...
متن کاملRotating stall control for axial flow compressors
Plus BROWSE SEARCH IEEE XPLORE GUIDE SUPPORT View TOC Rotating stall control for axial flow compressors Belta, C. Guoxiang Gu Sparks, A. Banda, S. Dept. of Electr. & Comput. Eng., Louisiana State Univ., Baton Rouge, LA; This paper appears in: Decision and Control, 1998. Proceedings of the 37th IEEE Conference on Publication Date: 1998 Volume: 3, On page(s): 2557-2562 vol.3 Meeting Date: 12/16/1...
متن کاملRotating stall control for axial #ow compressors
Rotating stall is a primary constraint for the performance of axial #ow compressors. This paper establishes a necessary and su$cient condition for a feedback controller to locally stabilize the critical equilibrium of the uniform #ow at the inception of rotating stall. The explicit condition obtained in this paper provides an e!ective synthesis tool for rotating stall control. 2001 Elsevier Sci...
متن کاملOne-Dimensional design of a three-stage axial compressor with Its 3D numerical simulation
The purpose of this study is to design a three-stage axial compressor with identical pressure ratio which makes an adequate pressure ratio and efficiency in design point conditions with rotational velocity of 38000rpm and mass flow rate of 3.2kg/s. First of all, considering some restrictions such as Dehaller number more than 0.7 in all sections of the stator and the rotor, and relative Mach num...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Thermal Science
سال: 2018
ISSN: 0354-9836,2334-7163
DOI: 10.2298/tsci171025050z