Numerical simulation of performance of an axial turbine first stage
نویسندگان
چکیده
منابع مشابه
One-Dimensional design of a three-stage axial compressor with Its 3D numerical simulation
The purpose of this study is to design a three-stage axial compressor with identical pressure ratio which makes an adequate pressure ratio and efficiency in design point conditions with rotational velocity of 38000rpm and mass flow rate of 3.2kg/s. First of all, considering some restrictions such as Dehaller number more than 0.7 in all sections of the stator and the rotor, and relative Mach num...
متن کاملNumerical Investigation of Rotating-Stall in a Stage of an Axial Compressor with Two Different Approaches
An unsteady two-dimensional finite-volume solver was developed based on Van Leer’s flux splitting algorithm in conjunction with “Monotonic Upstream Scheme for Conservation Laws (MUSCL)” limiters and the two-layer Baldwin-Lomax turbulence model was also implemented. To validate the solver, two test cases were prepared and the computed results had good agreements with reference data. The rotating...
متن کاملNumerical investigation of clocking in a two-stage gas turbine
Flow in the first two-stage of V 94.2 gas turbine is simulated numerically. In this turbine, the second stator is clocked relative to the first stator to different positions. Steady-state analysis was carried out by varying the circumferential relative position of the consecutive stator vanes to study the effects of the clocking on turbine performance. A density based compressible inviscid ...
متن کاملA Numerical Investigation on the Unstable Flow in a Single Stage of an Axial Compressor
An unsteady two-dimensional finite-volume solver was developed based on Van Leer’s flux splitting algorithm in conjunction with “Monotonic Upstream Scheme for Conservation Laws (MUSCL)” limiters to improve the order of accuracy and the two-layer Baldwin-Lomax turbulence model was also implemented. Two test cases were prepared to validate the solver. The computed results were compared with the e...
متن کامل3-D Numerical Simulation of Gas Turbine Combustor
This paper presents a numerical solution for a changing combustor geometry. The effects of the geometric change on the main parameters of the chamber are considered. For this purpose the original geometry and the new one are simulated numerically by a 3-D CFD code and the results are compared. Finally, comments are presented regarding this change. A model is used for turbulence modeling and a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Aerospace Technology and Management
سال: 2012
ISSN: 2175-9146
DOI: 10.5028/jatm.2012.04025411