Numerical Simulation of Mixer-Ejector Flow Field.
نویسندگان
چکیده
منابع مشابه
Cfd Simulation Of Flow Field In An Inject Pipe Mixer
The Inject Pipe Mixer (IPM) are being used as venturi injectors and can also homogenize two fluids. The entry of secondary fluid as a jet influences flow field in the device. A CFD simulation of flow through an IPM (Lshape) has been carried out using ANSYS CFX 11.0 using water as the flowing fluid to understand the flow field under turbulent flow conditions using standard k--ε model. The result...
متن کاملNumerical Simulations of Lobed Mixer Flow Fields
The applicability of a three-dimensional, steady, compressible, unstructured-mesh, viscous, Navier-Stokes solver and a two-dimensional, unsteady, slender-body approximation was studied for the investigation of lobed mixer flow fields. The viscous flow solver was evaluated for its ability to calculate the shed streamwise circulation, its subsequent downstream evolution and the thrust. The effect...
متن کاملNumerical simulation of in-cylinder tumble flow field measurements and comparison to experimental results
This paper presents a comparison between measured and predicted results of the in-cylinder tumble flow and the flow coefficient generated by a port-valve-liner assembly on a steady-flow test bench. In this study, computational fluid dynamics (CFD) methods were employed to gain further insight into characteristics of an engine. The purpose was to advance understanding of the stationary turbulenc...
متن کاملThe Numerical Simulation of Gas Turbine Inlet-Volute Flow Field
The structural and aerodynamic performance of the air inlet volute has an important influence on the performance of the gas turbine. On one hand, it requires the airflow flowing through inlet volute as even as possible, in order to reduce the pressure loss, to avoid a decrease in the effective output power and an increase of the fuel consumption rate of the internal combustion engine which indi...
متن کاملNumerical Simulation on Flow Field of Oilfield Three-Phase Separator
The conventional measurement method can no longer guarantee the accuracy requirement after the oilfield development entering high water cut stage, due to the water content and gas phase in the flow. In order to overcome the impact of measurement deviation the oilfield productionmanagement, the flow field of three-phase separator is studied numerically in this paper using Fluent 6.3.26. Taking i...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B
سال: 1997
ISSN: 0387-5016,1884-8346
DOI: 10.1299/kikaib.63.1994