Numerical simulation of mass transfer in centrifugal evaporator
نویسندگان
چکیده
منابع مشابه
Numerical Investigation of Turbulent Mass Transfer in a 90° Bend
This paper presents a numerical study of local mass transfer coefficients in a 90° bend using the RNG version of k–e model to include the influence of curvature on the turbulent transport. Simulations were performed for flow through a 90°, 3-D bend for Reynolds numbers of 13500, 90000, and 390000, Schmidt numbers of 2.53 and 700 and curvature ratios of 1.5, 2, and 2.5. The differences betwe...
متن کاملExperimental Study and Three-Dimensional Numerical Flow Simulation in a Centrifugal Pump when Handling Viscous Fluids
In this paper the centrifugal pump performances are tested when handling water and viscous oils as Newtonian fluids. Also, this paper shows a numerical simulation of the three-dimensional fluid flow inside a centrifugal pump. For these numerical simulations the SIMPLEC algorithm is used for solving governing equations of incompressible viscous/turbulent flows through the pump. The k-ε turbulenc...
متن کاملHeat Transfer, Mass Transfer and Scaling Characteristics in a Long Tube, Climbing Film, Pilot Plant Evaporator
ing characteristics could be investigated. Finally the pilot plant A single tube plant Kestner evaporator'was set up at was run under 1st effect conditions in order that a comparison Illovo to investigate heat transfer characteristics when could be made with industrial 1st effect evaporators (both simulating different evaporator Tests carried out have Roberts and Kestner). This particular trial...
متن کاملParametric Study of Centrifugal Fan Performance: Experiments and Numerical Simulation
In this paper, effect of geometric parameters of a centrifugal fan with backwardand forward-curved blades has been investigated. Centrifugal fans are used for enhancing the heat dissipation from the IC engine surfaces. In the process, the fan consumes power generated from the engine. As a first step, an experimental setup was developed and prototypes of fans were made to carry out measurements ...
متن کاملSimulation of Stresses Induced by Heat and Mass Transfer in Drying Process of Clay-like Material
Drying represents one of the oldest unit operations employed in industrial processes. Drying is viewed as a process of simultaneous heat and mass transfer. Porous Clay-like material undergoes stresses due to non-uniform distribution of temperature and moisture induced by heat and mass transfer respectively. The aim of this work is to simulate the stresses induced by heat and mass transfer durin...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Scientific and Technical Journal of Information Technologies, Mechanics and Optics
سال: 2017
ISSN: 2226-1494
DOI: 10.17586/2226-1494-2017-17-1-151-158