Numerical simulation of fatigue crack growth in friction stir welded T joint made of Al 2024 T351 alloy
نویسندگان
چکیده
منابع مشابه
Fatigue of Friction Stir Welded 2024-T351 Aluminium Alloy
Fatigue failure characteristics of friction stir welds in 13mm gauge 2024-T351 plate have been assessed. Failure occurred from either the weld region (nugget/flow arm) or from the material immediately surrounding the weld. Fatigue failure from the surrounding material was essentially conventional, initiating from large S-phase intermetallic particles and growing in a macroscopic mode I manner. ...
متن کاملTensile properties and fracture locations of friction-stir-welded joints of 2017-T351 aluminum alloy
Friction stir welding (FSW) is a new and promising welding process that can produce low-cost and high-quality joints of heat-treatable aluminum alloys because it does not need consumable filler materials and can eliminate some welding defects such as crack and porosity. In order to demonstrate the friction stir weldability of the 2017-T351 aluminum alloy and determine optimum welding parameters...
متن کاملNumerical Crack Growth Analysis in AA2024-T3 Friction Stir Welded Butt Joints
This paper deals with a numerical investigation on the influence of residual stresses on fatigue crack growth in AA2024-T3 friction stir welded butt joints. The computational approach is based on the coupled usage of the finite element method (FEM) and the dual boundary element method (DBEM), in order to take advantage of the main capabilities of the two methods. Linear elastic FE simulations a...
متن کاملCorrosion Behavior of the Friction Stir Welded AZ31 Magnesium Alloy.
* IDMEC, Instituto Superior Técnico, Universidade de Lisboa, Av. Rovisco Pais, 1049-001 Lisboa, Portugal ** DEQ/ICEMS, Instituto Superior Técnico, Universidade de Lisboa, Av. Rovisco Pais, 1049001 Lisboa, Portugal. *** Department of Engineering Design and Production, School of Engineering, Aalto University, P.O. Box 1420, FI-00076 Aalto, Finland **** Faculdade de Engenharia da universidade do P...
متن کاملOptimizing the Process Parameters of Friction Stir Welded Joint of Magnesium Alloy Az31b
This paper deals with Friction stir welding of AZ31B Mg alloy by using H13 Tool at different rotational speeds and welding speeds .Experiments were conducted according to L4 Orthogonal array which was suggested by Taguchi. Optimum parameters for optimum Tensile strength, Hardness and Ductility were found with the help of S/N ratios. Therefore optimization of input process parameter is required ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Structural Integrity
سال: 2016
ISSN: 2452-3216
DOI: 10.1016/j.prostr.2016.06.383