Numerical simulation of droplet-formation in rotary atomizer
نویسندگان
چکیده
منابع مشابه
simulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
Rotary Atomizer Drop Size Distribution Database
Wind tunnel measurements of drop size distributions from Micronair AU4000 and AU5000 rotary atomizers were collected to develop a database for model use. The measurements varied tank mix, flow rate, air speed, and blade angle conditions, which were correlated by multiple regressions (average R2 = 0.995 for AU4000 and 0.988 for AU5000). This database replaces an outdated set of rotary atomizer d...
متن کاملDetailed Numerical Simulation of Droplet Combustion
Auto-ignition and combustion of single fuel droplets of methanol, n-heptane and iso-octane are studied. The numerical simulations are based on a detailed vaporization model, a detailed transport model and detailed chemical kinetics. The governing equations of the two phases are solved in a fully coupled way. The influence of different physical parameters like droplet temperature, gas phase temp...
متن کاملSimulation of Spray Transport from Rotary Cup Atomizer using KIVA-3V
A numerical study of airflow and spray transport from rotary cup atomizer using KIVA-3V is carried out. The numerical result show that the electrostatic field speed up spray droplet speed and improve transfer efficiency. Breakup model produces smaller drops which are entrained into the center recirculation zone. The results of a parametric study considering different cup rotational speed, shapi...
متن کاملWellbore Stability in Shale Formation Using Analytical and Numerical Simulation
Optimization of drilling fluid parameters such as mud weight, salt concentration, and temperature is essential to alleviate instability problems during drilling through shale sections. The selection of suitable mud parameters can benefit from analyses that consider significant instability processes involved in shale-drilling–fluid interactions. This paper describes the development of analytical...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Theoretical and Applied Mechanics Letters
سال: 2019
ISSN: 2095-0349
DOI: 10.1016/j.taml.2019.03.015