Numerical Simulation of Decarburization Kinetics for Fe-3%Si Steel during Annealing
نویسندگان
چکیده
منابع مشابه
Kinetics of Austenite Recrystallization during the Annealing of Cold-rolled Fe-Mn-Al-C Steel
In the current study, the recrystallization behavior of 75% cold-rolled Fe-22Mn-10Al-1.4C steel during annealing at 750, 770, 790, 810, and 830°C was studied. X-ray diffraction patterns and optical microscopy were used to characterize microstructures. The Vickers Micro-hardness test was used to characterize recrystallization kinetics during annealing. Johnson-Mehl-Avrami-Kolmogorov (JMAK) model...
متن کاملAn investigation on full annealing temperature and annealing twins’ Density in Fe-33Mn-3Si-2Al high-manganese steel
Twinning induced plasticity (TWIP) steels with high manganese percentage (17-35%), are mostly used in automotive bodies. Their microstructure at room temperature is austenitic, and due to the low stacking fault energy, major deformation mechanism in them is twinning inside austenite grains which leads to enhanced mechanical strength in the steel. Due to the important effect of heat treatment pr...
متن کاملNumerical Simulation for Biochemical Kinetics
In chemical systems formed by living cells, the small numbers of molecules of a few reactant species can result in dynamical behavior that is discrete and stochastic, rather than continuous and deterministic (McAdams & Arkin, 1999; McAdams & Arkin, 1997; Arkin et al., 1998; Elowitz et al., 2002; Fedoroff & Fontana, 2002). By “discrete”, we mean the integer-valued nature of small molecular popul...
متن کاملsimulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
Measurement of Decarburization of Heat Treated Steel Surfaces
Decarburization is a significant problem in the heat treatment of steels as decarburization is detrimental to wear life and fatigue life of components. This presentation concentrates on its measurement by four procedures. Test results from an interlaboratory test of steels with spheroidize annealed, lamellar pearlite (normalized) and quenched and tempered martensitic microstructures were evalua...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ISIJ International
سال: 2019
ISSN: 0915-1559,1347-5460
DOI: 10.2355/isijinternational.isijint-2018-547