Numerical simulation of acoustic emission during crack growth in 3-point bending test
نویسندگان
چکیده
منابع مشابه
Cluster Analysis of Acoustic Emission Signals for Carbon/Epoxy Composite in Four-point Bending Test (RESEARCH NOTE)
Due to the extensive use of composites in various industries and the fact that defects reduce ultimate strength and efficiency during operation, detection of failures in composite parts is very important. The aim of this paper is to use Acoustic Emission (AE) non-destructive method in four-point bending test of carbon/epoxy composite to analyze and examine the failure mechanisms. This method is...
متن کاملDetection of crack growth in rail steel using acoustic emission
Increased traffic speeds and axle loads on modern railways enhance rail track degradation. To eliminate track failure due to rail defects, a condition monitoring system requires methods for the early detection of defects which grow in service. Acoustic emission (AE) monitoring is the only non-destructive technique which might be applied online to study the defect growth under traffic loading. H...
متن کاملAcoustic Emission during Stress Corrosion Cracking Test
AE monitoring from various types of stress corrosion cracking (SCC) has been conducted for the past 15 years in our laboratory. This paper discusses AE results of active-path dissolution-type SCC of austenitic stainless steel in chloride solution and fused salt, fluoride and polythionic acid solutions, brass in ammonia (Mattosson's solution), and carbon steels in nitrite solution. Transgranular...
متن کاملAcoustic Emission Crack Detection in Injection Molding
This paper presents the experimental results regarding acoustic emission signals measured during the injection molding of those standard test specimens commonly used for examining the shrinkage behaviour of various thermoplastic materials. In daily industrial production of different plastic products we often have to deal with various errors that practically occur on the mold primarily as a resu...
متن کاملAcoustic Emission from a Growing Crack
An analytical method is being developed to determine the signature of an acoustic emission waveform from a growing crack and the results of this analysis are compared to experimentally obtained values. Within the assumptions of linear elastic fracture mechanics, a two dimensional model is developed to examine a semi-infinite crack that, after propagating with a constant velocity, suddenly stops...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Structural Control and Health Monitoring
سال: 2017
ISSN: 1545-2255
DOI: 10.1002/stc.1996