Numerical Simulation for Optimization of Ultra-thin n-type AZO and TiO2 Based Textured p-type c-Si Heterojunction Solar Cells

نویسندگان

چکیده

A maximum efficiency of 17 % for ultra-thin n-type AZO layer and 17.5 TiO2 based silicon heterojunction solar cell is reported by optimizing its properties which much higher than practically obtained signifying a lot improvements can be performed to improve TiO2/Si AZO/Si cell. used as emitter crystalline wafer p-type (p-cSi) modelling heterojunctions respectively using AFORS HET automat simulation software. Various parameters like thickness AZO, layer, p-cSi doping concentration donors (Nd) effective conduction band density (Nc) are optimized. Finally, texturing at different angle studied 70 μm thick Silicon wafer, that very helpful manufacturing low cost HJ cells industrial scale because thin removal additional processing setup required deposition amorphous i-layer. Utilization Aluminium doped Zinc Oxide help in producing efficient (HJ) compared with intrinsic HIT cells.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Silicon Heterojunction Solar Cells on N- and P-type Wafers

A systematic comparison of frontand rear-emitter silicon heterojunction solar cells produced on nand p-type wafers was performed, in order to investigate their potential and limitations for high efficiencies. Cells on p-type wafers suffer from reduced minority carrier lifetime in the low-carrier-injection range, mainly due to the asymmetry in interface defect capture cross sections. This leads ...

متن کامل

a-Si/c-Si1-xGex/c-Si Heterojunction Solar Cells

The performance and material quality requirements of thin film a-Si/c-Si1-xGex/Si heterojunction solar cells are investigated by modeling and simulation. The effects of Ge content, Si1-xGex thickness, Si1-xGex lifetime and a-Si/c-Si1-xGex interfacial quality have been studied. The simulations predict that Si1-xGex based thin film solar cells provide a significant increase in solar cell output c...

متن کامل

p-type Mesoscopic Nickel Oxide/Organometallic Perovskite Heterojunction Solar Cells

In this article, we present a new paradigm for organometallic hybrid perovskite solar cell using NiO inorganic metal oxide nanocrystalline as p-type electrode material and realized the first mesoscopic NiO/perovskite/[6,6]-phenyl C61-butyric acid methyl ester (PC61BM) heterojunction photovoltaic device. The photo-induced transient absorption spectroscopy results verified that the architecture i...

متن کامل

Understanding of Passivation Mechanism in Heterojunction c-Si Solar Cells

Intrinsic hydrogenated amorphous silicon (a-Si:H) films can yield in outstanding electronic surface passivation of crystalline silicon (c-Si) wafers as utilized in the HIT (heterojunction with intrinsic thin layer) solar cells. We have studied the correlation between the passivation quality and the interface nature between thin amorphous layers and an underlying c-Si substrate for understanding...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Silicon

سال: 2021

ISSN: ['1876-9918', '1876-990X']

DOI: https://doi.org/10.1007/s12633-021-01212-2