Numerical Simulation and Response of Stiffened Plates Subjected to Noncontact Underwater Explosion

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

A Second Order Accurate Method in Simulation of Underwater Explosion

In this paper, a numerical scheme is proposed for the multi-fluid compressible flows. This method is applied to the problem of underwater explosion. The proposed scheme is basically the extension of Godunov method in gas dynamic problems to the multifluid environments and is second-order accurate in space. In this method, also, the problem of artificial mixing of two different phases on Euleria...

متن کامل

A Second Order Accurate Method in Simulation of Underwater Explosion

In this paper, a numerical scheme is proposed for the multi-fluid compressible flows. This method is applied to the problem of underwater explosion. The proposed scheme is basically the extension of Godunov method in gas dynamic problems to the multifluid environments and is second-order accurate in space. In this method, also, the problem of artificial mixing of two different phases on Euleria...

متن کامل

Numerical Simulation of Piles Subjected To Lateral Spreading and Comparison with Shaking Table Results

Pile foundations are relatively vulnerable to lateral loads. During liquefaction-induced lateral spreading, this vulnerability is particularly conspicuous due to a loss of strength and stiffness in the liquefied soil. A nonlinear effective stress analysis incorporating an elastoplastic constitutive model based on Finite Difference Method (FLAC2D program) was used to numerically simulate shake t...

متن کامل

Experimental and Numerical Simulation Investigation on Crushing Response of Foam-Filled Conical Tubes Stiffened with Annular Rings

In this paper, crashworthiness characteristics of conical steel tubes stiffened by annular rings and rigid polyurethane foam are investigated. For this purpose, wide circumferential rings are created from the outer surface of the conical tube at some determined areas along tube length. In fact, this method divides a long conical tube into several tubes of shorter length. When this structure is ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Advances in Materials Science and Engineering

سال: 2014

ISSN: 1687-8434,1687-8442

DOI: 10.1155/2014/752586