Numerical Prediction of Process Window for Injection-Compression Molding of 7-inch LGP
نویسندگان
چکیده
منابع مشابه
Finding efficient frontier of process parameters for plastic injection molding
Product quality for plastic injection molding process is highly related with the settings for its process parameters. Additionally, the product quality is not simply based on a single quality index, but multiple interrelated quality indices. To find the settings for the process parameters such that the multiple quality indices can be simultaneously optimized is becoming a research issue and ...
متن کاملThe Numerical Analysis and Validation of Compression Molding Process
In this work, the simulation results from a program developed for the three-dimensional analysis of compression molding of thermoset composites were compared to the experimental results of an actual molded thermoset sample. The program predicts the flow pattern, fiber orientation, fiber length distribution, curing of the resin and mechanical properties. The comparison between simulation and exp...
متن کاملPrecision Injection Molding PRECISION PROCESS CONTROL OF INJECTION MOLDING
1 INTRODUCTION The technical requirements of precision injection molded components demand a heightened level of process performance, and with corresponding process monitoring and control technologies. To obtain the desired critical to quality attributes (CTQs) of the molded products, the injection molding process must be consciously designed such that the key process variables (KPVs) are observ...
متن کاملsimulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
Injection Compression Molding of Replica Molds for Nanoimprint Lithography
As a breakthrough in the cost and durability of molds for nanoimprint lithography (NIL), replica molds are fabricated by injection compression molding (ICM). ICM is commonly used for optical disks such as DVDs or Blu-ray disks and is also a practical fabrication method for nanostructures. In this paper, I successfully demonstrated the fabrication of cycloolefin polymer replica molds with struct...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of Materials Processing
سال: 2011
ISSN: 1225-696X
DOI: 10.5228/kstp.2011.20.1.5