NUMERICAL MODELLING OF EXTRUSION PROCESS IN SUPERPLASTIC FLOW RANGE
نویسندگان
چکیده
منابع مشابه
Numerical Analysis of Az61 Magnesium Alloy Extrusion Process by Modified Equal Channel Angular Extrusion (ecae) Method
T. Bajor, M. Krakowiak, P. Szota, Czestochowa University of Technology, Czestochowa, Poland The paper presents the results of numerical modelling of AZ61 magnesium alloy hot deformation using modified ECAE method. The temperature-velocity conditions were analysed using FEM. The extrusion process was realised using the die with modified angular channel containing horizontal contracting zone in t...
متن کاملexperimental and numerical modelling of flow pattern on
abstract weirs are the most common structures for discharge measurement in engineering research. streamline curvature, non hydrostatic pressure distribution on weir and nappe adherence to the weir lead to differences between calculated and measured discharges. thus discharge coefficient, which is the ratio of real and theoretic discharges, is usually less than unity. in circular weirs the press...
متن کاملNumerical study and genetic algorithm optimization of hot extrusion process to produce rectangular waveguides
Rectangular waveguide is one of the earliest types of transmission lines. Rectangular waveguide can be produced by hot extrusion process. In this paper, the hot extrusion process of CuZn5 rectangular waveguide was investigated by Finite Element Method (FEM). In addition, Genetic Algorithm (GA) was used to optimize the die geometry and process conditions to achieve the lowest magnitude of extrus...
متن کاملUpper bound and numerical analysis of cyclic expansion extrusion (CEE) process
Deformation of the material during cyclic expansion extrusion (CEE) is investigated using upper-bound theorem. The analytical approximation of forming loads agrees very well with the FEM results for different amounts of chamber diameter, friction factor and also for lower die angles. However, the difference between analytical and numerical solution increases at higher die angles which are expla...
متن کاملNumerical Modelling of Flow and Coupled Mass and Heat Transfer in an Adsorption Process
In this paper, a detailed 3D modelling of flow and coupled heat and mass transport in a channel coated with adsorbing material is presented. A comparative study between a simplified 1D model and the detailed 3D model is carried out. Both 3D and 1D predictions are compared with experimental data available from literature as well. The time-dependent variation of temperature and heat flux distribu...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Metallurgy and Foundry Engineering
سال: 2006
ISSN: 1230-2325
DOI: 10.7494/mafe.2006.32.1.41