Numerical modelling of 3D dowelled timber joints using advanced fully coupled hydro-mechanical constitutive equations
نویسندگان
چکیده
منابع مشابه
Numerical Modelling of Timber Braced Frame Masonry Structures (Dhajji Dewari)
This paper presents numerical modeling technique for Dhajji-Dewari structures (timber-braced rubble stone masonry), and its application for the evaluation of in-plane force-deformation capacity of Dhajji wall panels of different configuration of bracings. Dhajji structures are mainly composed of vertical and horizontal timber posts and braced using diagonal bracings and horizontal studs. Wall o...
متن کاملUsing Fully Coupled Hydro-geomechanical Numerical Test Bed to Study Reservoir Stimulation with Low Hydraulic Pressure
This paper documents our effort to use a fully coupled hydro-geomechanical numerical test bed to study using low hydraulic pressure to stimulate geothermal reservoirs with existing fracture network. In this low pressure stimulation strategy, fluid pressure is lower than the minimum in situ compressive stress, so the fractures are not completely open but permeability improvement can be achieved ...
متن کاملHydro - mechanical forming of aluminium tubes - on constitutive modelling and process design
Tube hydroforming is a forming method which has several advantages. By using pressure in combination with material feeding it is possible to manufacture products with high structural integration and tight dimensional tolerances. The forming method is especially suited for aluminium alloys which have a relatively low ductility. Finite Element simulations are used extensively in the sheet metal s...
متن کاملElectromigration induced stress analysis using fully coupled mechanical–diffusion equations with nonlinear material properties
Electromigration is a major road block in the pursuit of further miniaturized electronics. In the next generation micro and sub micro electronics current density is expected to exceed 10 A/cm. In this paper an electromigration induced strain-current density model is proposed and implemented in finite element procedure for solution of boundary/initial value electromigration problems. Numerical s...
متن کاملAdvances in Numerical Modelling of Adhesive Joints
The analysis of adhesively bonded joints started in 1938 with the closed-form model of Volkersen. The equilibrium equation of a single lap joint led to a simple governing differential equation with a simple algebraic equation. However, if there is yielding of the adhesive and/or the adherends and substantial peeling is present, a more complex model is necessary. The more complete is an analysis...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Mechanics & Industry
سال: 2015
ISSN: 2257-7777,2257-7750
DOI: 10.1051/meca/2015034