Numerical modal analysis of DTU 10-MW reference wind turbine’s blade using modified Myklestad´s method

نویسندگان

چکیده

Since the rotor blade system of an horizontal axis wind turbine is responsible for converting energy into mechanical, which turns electrical and predicting its dynamic behavior vital importance. In that sense, this paper deals with performing a modal analysis belonging to DTU 10-MW reference by using modified Myklestad’s method. The model was built on two different keystones, as follows: first, considering uncoupled bending in out-of-plane (flapwise) in-plane (edgewise) directions coupled bending-torsion motion also both directions. order accomplish these objectives, Python code implemented. computed eigenfrequencies were compared results obtained finite element Besides, mode shapes plotted centrifugal stiffening taken account. Results suggest feasibility method purposes, since good agreement data achieved has considerably less complex implementation than

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Integrated airfoil and blade design method for large wind turbines

This paper presents an integrated method for designing airfoil families of large wind turbine blades. For a given rotor diameter and tip speed ratio, the optimal airfoils are designed based on the local speed ratios. To achieve high power performance at low cost, the airfoils are designed with an objective of high Cp and small chord length. When the airfoils are obtained, the optimum flow angle...

متن کامل

Inverse Design of Blade Shapes for Vertical Axis Wind Turbines

An inverse design process is applied to determine blade shapes used in vertical axis wind turbines (VAWTs). The method is based on the modified Garabedian-McFadden technique that uses the deviation of the pressure distribution or the velocity distribution on the surface from a target pressure or velocity distribution, and modifies the blade surface in order to reduce this deviation. The method ...

متن کامل

Aeroelasticity of Wind Turbines Blades Using Numerical Simulation

With roller coaster traditional fuel prices and ever increasing energy demand, wind energy has known significant growth over the last years. To pave the way for higher efficiency and profitability of wind turbines, advances have been made in different aspects related to this technology. One of these has been the increasing size of wind turbines, thus rendering the wind blades gigantic, lighter ...

متن کامل

Two LQRI based Blade Pitch Controls for Wind Turbines

As the wind turbine size has been increasing and their mechanical components are built lighter, the reduction of the structural loads becomes a very important task of wind turbine control in addition to maximum wind power capture. In this paper, we present a separate set of collective and individual pitch control algorithms. Both pitch control algorithms use the LQR control technique with integ...

متن کامل

Dynamic Analysis of Wind Farm Using Induction Generator Wind Turbines

The vast majority of wind turbines that are currently being installed use one of the three main types of electromechanical conversion system. The first type is known as the Danish concept. The second type uses a doubly fed induction generator instead of a squirrel cage induction generator. The third type is called the ‘direct-drive wind turbine’ because it does not need a gearbox. In this paper...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Applied and Computational Mechanics

سال: 2022

ISSN: ['1802-680X', '2336-1182']

DOI: https://doi.org/10.24132/acm.2022.728