Numerical investigation into the effectiveness of steel i-beam strengthening techniques in steel-framed buildings

Modeling Steel Frame Buildings in Three Dimensions. I: Panel Zone and Plastic Hinge Beam Elements

A procedure for efficient three-dimensional nonlinear time-history analysis of steel framed buildings is derived. It incorporates two types of nonlinear beam elements—the plastic hinge type and the elastofiber type—and nonlinear panel zone elements to model yielding and strain-hardening in moment-frames. Floors and roofs of buildings are modeled using 4-node elastic diaphragm elements. The proc...

Free vibration analysis of steel framed structures

This study based on free vibration analysis and study the behavior of framed structure under different frequency of vibration using ANSYS software and shaking table. A small scale uni-axial shaking table was prepared in laboratory, which can produce lower to moderate vibration, regarding frequency and velocity. Moment resisting framed structures constructed with connecting beam and column eleme...

Building information modelling for sustainability appraisal of conceptual design of steel-framed buildings

Seismic Response of Steel Framed Hospital Buildings with Self-Centering Systems (2004-2005)

This paper introduces the concepts of Elasto-Plastic Systems (EPS) and Self-Centering Systems (SCS) for the seismic design of steel-framed hospital buildings. Redesign of the MCEER West Coast Demonstration Hospital with SCS is conducted using this approach. An ensemble of 25 simulated MCEER Ground Motions having a probability of exceedence of 5% in 50 years in Northridge, California is used as ...

ANALYTICAL STUDY OF STEEL I-BEAM WITH STEPPED FLANGES

This paper presents a parametric study of steel I- beam with stepped flanges by using finite element analysis. Stepped flange beam is used in structures to decrease the negative bending moments near interior supports that causes failure due to buckling. Steps in the cross section can be achieved by adding cover plates to the beam flanges, changing the size of the hot rolled section, or changing...