Numerical and Experimental Investigations of Lift and Drag Performances of NACA 0015 Wind Turbine Airfoil
نویسندگان
چکیده
منابع مشابه
Numerical Investigation of S822 Wind Turbine Airfoil
We carried out direct numerical simulations of the flow past a two-dimensional S822 wind turbine blade section at a chord Reynolds number of Re=100,000 and an angle of attack of α = 5deg. Without blade rotation the separated boundary layer “rolls up” into spanwise vortices which then “break up” into smaller scale structures leading to transition to turbulence. Simulation results compare favorab...
متن کاملoptimization of an airfoil used in the tip of wind turbine blades for maximizing its lift to drag coefficients ratio
0
متن کاملVerification of a CFD solver in near ground effect for aerodynamic behavior of airfoil NACA 0015
Numerical investigation was performed on NACA 0015 which is a symmetric airfoil. Pressure distribution and then lift and drag forces are verified. Changing of ground clearance was a considerable point. Also the angle of attack was changed from 0° to 10°. Pressure coefficient reaches its higher amounts on the wing lower surface when the ground clearance diminishes. Increment of the angle of atta...
متن کاملFlow Physics of Separated Flow over a Naca 0015 Airfoil and Detection of Flow Separation
J. P. Bonnet, W. L. Siauw, L. Cordier, J. Tensi Laboratoire d’Etudes Aérodynamiques, UMR CNRS 6609, ENSMA, Téléport 2, 1 Av. Clément Ader, BP 40109, 86961 Futuroscope Chasseneuil Cedex, France Bernd R. Noack Berlin Institute of Technology MB1 Straße des 17. Juni 135, D-10623 Berlin, Germany L. N. Cattafesta III Interdisciplinary Microsystems Group, University of Florida, Gainesville, FL, USA 32611
متن کاملComputational and experimental investigations of an omni-flow wind turbine
Both numerical and experimental studies were conducted to evaluate the performance of an omni-flow wind turbine designed to provide renewable electricity on the top of urban buildings like skyscrapers. The numerical approach was based on Finite Volume Method (FVM) and the turbulence flow was studied with several commonly used Reynoldsaveraged Navier-Stokes turbulence models. The results of the ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Materials, Mechanics and Manufacturing
سال: 2015
ISSN: 1793-8198
DOI: 10.7763/ijmmm.2015.v3.159