Numerical Analysis of CNC Milling Chatter Using Embedded Miniature MEMS Microphone Array System
نویسندگان
چکیده
منابع مشابه
Prediction of Chatter in CNC Machining based on Dynamic Cutting Force for Ball End Milling
This paper presents the suitable depth of cut, spindle speed and feed rate that will be chosen during machining. If thus parameters are not considered, this can provoke abnormal tool behavior such as chatter. Chatter will limit the tool life which only can be use for just a few times. To predict the chatter occurs, the parameters will be use are spindle speed, depth of cut and feed rate. CNC ma...
متن کاملPhased array antenna using MEMS phase shifter
This article presents a phased array antenna employing MEMS phase shifter. The proposed phased array antenna consists of eight square patch antennas operating at 10.4 GHz with a bandwidth of 400 MHz. Feed line for each patch passes through a MEMS phase shifter realized by a series of bridges above the transmission line. The distance between the bridge and the transmission line underneath it is ...
متن کاملAnalysis of Chatter in Ball End Milling by Wavelet Transform
The chatter is one of the major limitations of the productivity in the ball end milling process. It affects the surface roughness, the dimensional accuracy and the tool life. The aim of this research is to propose the new system to detect the chatter during the ball end milling process by using the wavelet transform. The proposed method is implemented on the 5-axis CNC machining center and the ...
متن کاملMEMS Microphone Array Sensor for Air-Coupled Impact-Echo
Impact-Echo (IE) is a nondestructive testing technique for plate like concrete structures. We propose a new sensor concept for air-coupled IE measurements. By using an array of MEMS (micro-electro-mechanical system) microphones, instead of a single receiver, several operational advantages compared to conventional sensing strategies in IE are achieved. The MEMS microphone array sensor is cost ef...
متن کاملActive chatter control for high-speed milling using μ-synthesis
In todays manufacturing industry, high-speed milling plays an important role. The main benefits of high-speed milling over conventional milling are the high material removal rates with relatively low cutting forces. The efficiency of high-speed milling is limited by the occurrence of regenerative chatter. Chatter is an undesired instability phenomenon, causing excessive tool vibrations, reduced...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Inventions
سال: 2018
ISSN: 2411-5134
DOI: 10.3390/inventions3010005