Numerical Analysis of a Plastic Deformation Composite Panel
نویسندگان
چکیده
منابع مشابه
Numerical Analysis of Severe Plastic Deformation by High Pressure Torsion
High-pressure torsion (HPT) is a metal processing method in which the sample is subjected to a very high plastic shear deformation. This process can produce exceptional levels of grain refinement, and provides a corresponding improvement in mechanical properties. To investigate the stress and strain distribution due to HPT process finite element simulation were conducted to investigate effectiv...
متن کاملNumerical modelling of elastic-plastic deformation at crack tips in composite material under stress wave loading
The paper deals with the elastic-plastic wave propagations in an anisotropic material subjected to impact loading with emphasis on an ideal fibre-reinforced cubic material under two-dimensional plane strain condition. The system of partial differential equations is hyperbolic. Therefore a characteristic-based difference method is proposed to calculate the formation of the plastic zone at the cr...
متن کاملEBSD characterization of nano/ultrafine structured Al/Brass composite produced by severe plastic deformation
In the present work, nano/ultrafine structured Al/Brass composite was produced by accumulative roll bonding (ARB) up to eight cycles. The evolution of grain refinement and deformation texture and their effect on the mechanical properties were investigated. It was observed that by increasing the ARB cycles, due to the difference in flow properties of the metal constituents, brass layers necked, ...
متن کاملPlastic deformation analysis in parallel tubular channel angular pressing (PTCAP)
Parallel tubular channel angular pressing (PTCAP) process is a novel recently developed severe plastic deformation technique for fabrication of ultrafine grained (UFG) metallic tubes. This new process consists of two half cycles and is affected by several parameters such as channel angles, deformation ratio and curvature angles. In this paper, the effects of these parameters on the plastic defo...
متن کاملPLASTIC DEFORMATION BEHAVIOUR AT THE WORN SURFACE OF NOVEL CAST AL-ALLOY-TICP COMPOSITE
An AI-7wt%Si-5vol%TiCp was worn against a cast iron disc in a tri-pin-on-disc machine, under dry sliding conditions at the sliding speed of 0.24 m/s and applied loads of 6, 20 and 40 N/pin. Stress-strain (`3-^9) curves were constructed by measuring the microhardness and the equivalent strain gradients in near surface regions on the cross-sectional surface prepared parallel to sliding direction....
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materiale Plastice
سال: 2017
ISSN: 0025-5289,2668-8220
DOI: 10.37358/mp.17.3.4887