Numerical Analysis for Polymer Melt Flow in Injection Molding.
نویسندگان
چکیده
منابع مشابه
Online Monitoring Rheological Property of Polymer Melt during Injection Molding
Abstract—The detection of the polymer melt state during manufacture process is regarded as an efficient way to control the molded part quality in advance. Online monitoring rheological property of polymer melt during processing procedure provides an approach to understand the melt state immediately. Rheological property reflects the polymer melt state at different processing parameters and is v...
متن کاملImage Analysis Dedicated to Polymer Injection Molding
This work follows the general framework of polymer injection moulding simulation whose objectives are the mastering of the injection moulding process. The models of numerical simulation make it possible to predict the propagation of the molten polymer during the filling phase from the positioning of one point of injection or more. The objective of this paper is to propose a particular way to op...
متن کاملPolymer Injection Molding Technology for the Next Millennium
Injection molding technology continually develops, with major milestones including the introduction of the first thermoplastic materials, the reciprocating screw design, the first hot runner systems, engineering materials, the introduction of microprocessors for machine control, Computer Aided Engineering flow simulation software, and recently the application of expert systems for optimized mac...
متن کاملAnalysis of air injection system for drag reduction in high speed vessels using numerical simulation software ANSYS-Fluid Flow
Many existing phenomena in nature are considered new design ideas in various fields of industry. Bionics is the application of biological methods and systems found in nature to the study and design of engineering systems and modern technology. By performing bionic review, the researchers found the penguins by delivering air locked under their wings and creating air bubbles, the drag significant...
متن کاملStability analysis of injection molding flows
We numerically investigate the stability problem of the injection molding process. It was indicated by Bulters and Schepens Bulters and Schepens 2000 that surface defects of injection molded products may be attributed to a flow instability near the free surface during the filling stage of the mold. We examine the stability of this flow using the extended Pom–Pom constitutive equations. The mode...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JSME International Journal Series B
سال: 1994
ISSN: 1340-8054,1347-5371
DOI: 10.1299/jsmeb.37.531