Nucleation of fractal nanocrystallites upon annealing of Fe-based metallic glass
نویسندگان
چکیده
منابع مشابه
Fractal in fracture of bulk metallic glass
We investigate the nanoscale periodic corrugation (NPC) structures on the dynamic fracture surface of a typical tough bulk metallic glass, submitted to high-velocity plate impact and scanned by atomic force microscopy (AFM). The detrended fluctuation analysis (DFA) of the recorded AFM profiles reveals that the valley landscapes of the NPC are nearly memoryless, characterized by Hurst parameter ...
متن کاملHigh pressure die casting of Fe-based metallic glass
Soft ferromagnetic Fe-based bulk metallic glass key-shaped specimens with a maximum and minimum width of 25.4 and 5 mm, respectively, were successfully produced using a high pressure die casting (HPDC) method, The influence of die material, alloy temperature and flow rate on the microstructure, thermal stability and soft ferromagnetic properties has been studied. The results suggest that a stee...
متن کاملAb initio simulations of geometrical frustration in supercooled liquid Fe and Fe-based metallic glass
We investigate short range order in liquid and supercooled liquid Fe and Fe-based metallic glass using ab initio simulation methods. We analyze the data to quantify the degree of local icosahedral and polytetrahedral order and to understand the role of alloying in controlling the degree of geometric frustration. Comparing elemental Fe to Cu P. Ganesh and M. Widom, Phys. Rev. B 74, 134205 2006 w...
متن کاملFormation of nanostructured metallic glass thin films upon sputtering
Morphology evolution of the multicomponent metallic glass film obtained by radio frequency (RF) magnetron sputtering was investigated in the present work. Two modes of metallic glass sputtering were distinguished: smooth film mode and clustered film mode. The sputtering parameters, which have the most influence on the sputtering modes, were determined. As a result, amorphous Ni-Nb thin films wi...
متن کاملEffects of annealing and specimen geometry on dynamic compression of a Zr-based bulk metallic glass
High strain-rate compression experiments were performed with a split-Hopkinson pressure bar (SHPB) at 500–4000/s on cylindrical samples of a Zr-based bulk metallic glass (LM-1) in both the fully amorphous and annealed conditions. The effects of changes to the specimen geometry (i.e., L/D ratio) and the material heat treatment [i.e., annealing versus amorphous (as-received)], on the peak stress,...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Materials Research
سال: 2017
ISSN: 0884-2914,2044-5326
DOI: 10.1557/jmr.2017.79