Novel Method of Severe Plastic Deformation - Continuous Closed Die Forging: CP Aluminum Case Study
نویسندگان
چکیده
منابع مشابه
Repetitive forging (RF) using inclined punches as a new bulk severe plastic deformation method
A new bulk severe plastic deformation method based on repetitive forging (RF) using inclined punches is proposed. This process consists of two half cycles. In the first half cycle, a square cross section deforms to parallelogram by forging with two inclined punches, and the parallelogram cross section is forged back to square using two flat punches in the second half cycle. This method was appl...
متن کاملNumerical Analysis of Severe Plastic Deformation by High Pressure Torsion
High-pressure torsion (HPT) is a metal processing method in which the sample is subjected to a very high plastic shear deformation. This process can produce exceptional levels of grain refinement, and provides a corresponding improvement in mechanical properties. To investigate the stress and strain distribution due to HPT process finite element simulation were conducted to investigate effectiv...
متن کاملSevere Plastic Deformation of Metals
This paper provides an introduction in the field of severe plastic deformation (SPD). First of all the main methods to produce SPD materials are discussed. In the following section, the mechanisms leading to the formation of fine grains are reviewed and the influence of changes in strain path is highlighted. During post-SPD thermal annealing, some typical microstructural changes take place. The...
متن کاملNew geometry for TCP: severe plastic deformation of tubes
Since tubes are widely used for different industrial applications, processing of tubes by the Severe Plastic Deformation (SPD) method has been the target of different attempts. Among these attempts, development of SPD processes for tubes based on Equal Channel Angular Pressing (ECAP) has been more successful. As an illustration, Tube Channel Pressing (TCP) has been presented as an attractive SP...
متن کاملOptimum Designing of Forging Preform Die for the H-shaped Parts Using Backward Deformation Method and Neural Networks Algorithm
In a closed die forging process, it is impossible to form complex shapes in one stage, and thus it becomes necessary to use preform dies. In the present study, Backward Deformation Method and FE simulation via ABAQUS software has been used in order to design preform die of the H-shaped parts. In the Backward Deformation Method, the final shape of the part is considered as a starting point and u...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Defect and Diffusion Forum
سال: 2018
ISSN: 1662-9507
DOI: 10.4028/www.scientific.net/ddf.385.302