Note on Brinell and Scratch Tests for Hardened Steel
نویسندگان
چکیده
منابع مشابه
Copper Precipitation Hardened, High Strength, Weldable Steel
Steel containing 0.03% carbon, 1.35% copper and 0.84% nickel had yield strength in the 540-625 MPa (78-90 Ksi) range depending on thickness, ultimate tensile strength in the 625-690 MPa (90100 Ksi) range, and 25-30% elongation when air cooled after hot rolling. No brittle heat-affected zone was formed during manual or automatic submerged arc welding without pre-heating or postheating. The fract...
متن کاملFinite Element Analysis of Hardened Steel Cutting
Hard machining, as attractive replacement for many rough and finish grinding operation, generates high cutting forces and temperature that enhance tool wear when act together. Therefore, the tool geometry and machining parameters have to be carefully optimized for a given material. Because of high cost and time consuming experimental work up-to-date advanced software for modeling and simulation...
متن کاملOn machining of hardened AISI D2 steel with PCBN tools
This paper describes an experimental investigation on machining of a difficult-to-cut material, AISI D2 steel of hardness 62 HRC with PCBN tools. It was found that the most feasible feeds and speeds fall in the ranges 0.08–0.20 mm/rev and 70–120 m/min, respectively and that most of the tested PCBN tools reached the end of life mainly due to flank wear. The highest acceptable values of tool life...
متن کاملUltraprecision sculpturing of hardened steel by applying elliptical vibration cutting
Elliptical vibration cutting technology is well-known for its excellent performance in ultraprecision machining of steel materials with single crystal diamond tools. This paper presents two approaches to attain high-performance microand macro-scale sculpturing for steel materials by utilizing elliptical vibration cutting. In order to attain free-form sculpturing in macro-scale, a 4-axis control...
متن کاملInfluence of Workpiece Material on Tool Wear Performance and Tribofilm Formation in Machining Hardened Steel
In addition to the bulk properties of a workpiece material, characteristics of the tribofilms formed as a result of workpiece material mass transfer to the friction surface play a significant role in friction control. This is especially true in cutting of hardened materials, where it is very difficult to use liquid based lubricants. To better understand wear performance and the formation of ben...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Proceedings of the Institution of Mechanical Engineers
سال: 1919
ISSN: 0020-3483,2058-1203
DOI: 10.1243/pime_proc_1919_097_007_02