NORMAL PERFORATION OF THIN DURALUMIN PLATES AT ORDNANCE VELOCITIES
نویسندگان
چکیده
منابع مشابه
Mode Velocities in Graphite / Epoxy Plates
Measurements of the velocities of the extensional and flexural plate modes were made along three directions of propagation in four graphite/ epoxy composite plates. The acoustic signals were generated by simulated acoustic emission events (pencil lead breaks or Hsu-Neilsen sources) and detected by broad band ultrasonic transducers. The first arrival of the extensional plate mode, which is nondi...
متن کاملPlate Mode Velocities in Graphite / Epoxy Plates
Measurements of the velocities of the extensional and flexural plate modes were made along three directions of propagation in four graphite/ epoxy composite plates. The acoustic signals were generated by simulated acoustic emission events (pencil lead breaks or Hsu-Neilsen sources) and detected by broad band ultrasonic transducers. The first arrival of the extensional plate mode, which is nondi...
متن کاملAnalysis of Normal Penetration of Ogive -Nose Projectiles into Thin Metallic Plates
In this note, a theoretical model for analyzing of normal penetration of the ogive – nose projectile into metallic targets is presented .The failure is assumed to be asymmetry petalling and the analysis is performed by using the energy balance and work done .The work done consist of the work required for plastic deformation Wp, the work for transferring the matter to new position Wd and the wor...
متن کاملBEM of postbuckling analysis of thin plates
A new fundamental solution of deflection for plate buckling problems is first derived through the separation of in-plane stresses into an essential part and a disturbed part and by use of the resolution theorem of differential operator. A set of new boundary element formulas for the analysis of postbuckling problems of elastic plates are presented. On the basis of these formulas, in-plane and o...
متن کاملAsymptotic modeling of thin piezoelectric plates
We study the asymptotic behavior of a three dimensional flat, heterogeneous and anisotropic piezoelectric body when its thickness seen as a parameter goes to zero. Depending on the type of the electrical loading two models are obtained which are related to the plate used as a sensor or as an actuator. These models are explicitly derived in any piezoelectric crystal symmetry class. For some of t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Conference on Aerospace Sciences and Aviation Technology
سال: 1991
ISSN: 2636-364X
DOI: 10.21608/asat.1991.25782