Non-uniqueness with Refraction Inversion – A Syncline Model Study
نویسندگان
چکیده
منابع مشابه
Two-dimensional inversion of refraction traveltimes by progressive model development
We develop a systematic approach for the analysis of 2-D refraction experiments using traveltimes that allows progressive improvement of velocity structure through a sequence from 1-D models to pseudo-2-D models, and then 2-D models. The approach consists of three steps. First, 1-D velocity models are constructed for each segment of the pro¢le using a genetic algorithm inversion, and then pseud...
متن کاملComparing Geostatistical Seismic Inversion Based on Spectral Simulation with Deterministic Inversion: A Case Study
Seismic inversion is a method that extracts acoustic impedance data from the seismic traces. Source wavelets are band-limited, and thus seismic traces do not contain low and high frequency information. Therefore, there is a serious problem when the deterministic seismic inversion is applied to real data and the result of deterministic inversion is smooth. Low frequency component is obtained fro...
متن کاملa study on insurer solvency by panel data model: the case of iranian insurance market
the aim of this thesis is an approach for assessing insurer’s solvency for iranian insurance companies. we use of economic data with both time series and cross-sectional variation, thus by using the panel data model will survey the insurer solvency.
Joint inversion of ReMi dispersion curves and refraction travel times using particle swarm optimization algorithm
Shear-wave velocity ( ) is an important parameter used for site characterization in geotechnical engineering. However, dispersion curve inversion is challenging for most inversion methods due to its high non-linearity and mix-determined trait. In order to overcome these problems, in this study, a joint inversion strategy is proposed based on the particle swarm optimization (PSO) algorithm. The ...
متن کاملInversion of seismic refraction data in planar dipping structure
A new method is presented for the direct inversion of seismic refraction data in dipping planar structure. Three recording geometries, each consisting of two common-shot profiles, are considered: reversed, split, and roll-along profiles. Inversion is achieved via slant stacking the common-shot wavefield to obtain a delay time-slowness (tau-p) wavefield. The tau-p curves from two shotpoints desc...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ASEG Extended Abstracts
سال: 2010
ISSN: 2202-0586
DOI: 10.1081/22020586.2010.12041865