منابع مشابه
Steady - state thermal characteristics of AMR
Tape storage drives use lithographically deposited anisotropic magnetoresistive (AMR) sensors to read magnetic transitions written on tape. The read-back signal and the reliability of an AMR sensor are both affected by sensor temperature. Because current passes through the sensor, it is subject to joule heating, dependent on both the geometry of the sensor and the thermal conductivities of its ...
متن کاملNon-Equilibrium Steady States
The mathematical physics of mechanical systems in thermal equilibrium is a well studied, and relatively easy, subject, because the Gibbs distribution is in general an adequate guess for the equilibrium state. On the other hand, the mathematical physics of non-equilibrium systems, such as that of a chain of masses connected with springs to two (infinite) heat reservoirs is more difficult, precis...
متن کاملSteady-State Performance Characteristics of Photovoltaic System Coupled with a Centrifugal Water Pump
In this article our objective is to obtain steady state characteristics of shunt, series, and separately excited DC motors coupled with a centrifugal water pump supplied through a step-up, step-down, and cuk converter from photovoltaic generator. We assume that there are no storage batteries and, of course, the system must operate on maximum utilization i.e. maximum water must be pumped. It is ...
متن کاملDose-response characteristics of insulin action on glucose metabolism: a non-steady-state approach.
The traditional methods for the assessment of insulin sensitivity yield only a single index, not the whole dose-response curve information. This curve is typically characterized by a maximally insulin-stimulated glucose clearance (Cl(max)) and an insulin concentration at half-maximal response (EC(50)). We developed an approach for estimating the whole dose-response curve with a single in vivo t...
متن کاملSteady State Operability Characteristics of an Adiabatic Fixed-Bed Reactor for Methanol Dehydration
Operability analysis as one of the most important bridges between process design and process control helps the process designer to investigate the control issues quite early in the design stage. Recently, Vinson and Georgakis suggested a steady state geometrical operability index as a quantitative measure for assessment of process operability. In...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Society of Mechanical Engineers
سال: 1975
ISSN: 0029-0270,2185-9485
DOI: 10.1299/kikai1938.41.2622