Non-Intrusive Measurement of Workload in Real-Time
نویسندگان
چکیده
منابع مشابه
Non-intrusive Measurement of Workload in Real-time
We present a new method to measure workload that offers several advantages. First, it uses non-intrusive means: cameras and a mouse. Second, the workload is measured in real-time. Third, the setup is comparably cheap: the cameras and sensors are off-the-shelf components. Fourth, we go beyond measuring performance and demonstrate that just using such measures does not suffice to measure workload...
متن کاملReal-Time, Non-intrusive Evaluation of VoIP
Speech quality, as perceived by the users of Voice over Internet Protocol (VoIP) telephony, is critically important to the uptake of this service. VoIP quality can be degraded by network layer problems (delay, jitter, packet loss). This paper presents a method for real-time, non-intrusive speech quality estimation for VoIP that emulates the subjective listening quality measures based on Mean Op...
متن کاملOn Non-Intrusive Workload-Aware Database Replication
Performance and high-availability are the crucial factors in the development of nowadays distributed database systems. Both of these challenges are commonly addressed by means of the same technique, database replication. The overall throughput of the system is increased by leveraging parallel computation on different sites, and in case of replica failures, availability is improved by redirectin...
متن کاملExploiting Non-intrusive Monitoring in Real-Time Embedded Operating Systems
Monitoring in embedded system software can have several uses, ranging from system characterization to run-time verification (RV). Traditional monitoring techniques require code instrumentation, imposing an overhead on system execution both in performance and timeliness. In real-time systems this is exarcebated by the need of new worst-case execution time estimation and schedulability analysis. ...
متن کاملPrecise Continuous Non-Intrusive Measurement-Based Execution Time Estimation
Precise estimation of the Worst-Case Execution Time (WCET) of embedded software is a necessary precondition in safety critical systems. Static methods for WCET analysis rely on precise models of the target processor’s micro-architecture. Measurement-based methods, in contrast, rely on exhaustive measurements performed on the real hardware. The rise of the multicore processors often renders stat...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Proceedings of the Human Factors and Ergonomics Society Annual Meeting
سال: 2005
ISSN: 2169-5067,1071-1813
DOI: 10.1177/154193120504901213