Non-conventional techniques for optical lithography
نویسندگان
چکیده
منابع مشابه
Sub-micron silicon nitride waveguide fabrication using conventional optical lithography.
We demonstrate a novel technique to fabricate sub-micron silicon nitride waveguides using conventional contact lithography with MEMS-grade photomasks. Potassium hydroxide anisotropic etching of silicon facilitates line reduction and roughness smoothing and is key to the technique. The fabricated waveguides is measured to have a propagation loss of 0.8dB/cm and nonlinear coefficient of γ = 0.3/W...
متن کاملNon-invasive Optical Techniques for determination of blood Glucose levels: A Review Article
This article reviews the development of non-invasive optical techniques for determination of blood glucose concentrations in diabetic patients. Early diagnosis and daily management are essential for ensuring the healthy life of diabetic patients. The determination of blood glucose concentration with common devices involves the chemical analysis of blood samples, which are obtained by pricking t...
متن کاملEUV Lithography—The Successor to Optical Lithography?
This paper discusses the basic concepts and current state of development of EUV lithography (EUVL), a relatively new form of lithography that uses extreme ultraviolet (EUV) radiation with a wavelength in the range of 10 to 14 nanometer (nm) to carry out projection imaging. Currently, and for the last several decades, optical projection lithography has been the lithographic technique used in the...
متن کاملAbsorbance-modulation optical lithography.
We describe a new mode of optical lithography called absorbance-modulation optical lithography (AMOL) in which a thin film of photochromic material is placed on top of a conventional photoresist and illuminated simultaneously by a focal spot of wavelength lambda1 and a ring-shaped illumination of wavelength lambda2. The lambda1 radiation converts the photochromic material from an opaque to a tr...
متن کاملLossless Compression Techniques for Maskless Lithography Data
Future lithography systems must produce more dense chips with smaller feature sizes, while maintaining the throughput of one wafer per sixty seconds per layer achieved by today’s optical lithography systems. To achieve this throughput with a direct-write maskless lithography system, using 25 nm pixels for 50 nm feature sizes, requires data rates of about 10 Tb/s. In a previous paper, we present...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Microelectronic Engineering
سال: 1995
ISSN: 0167-9317
DOI: 10.1016/0167-9317(94)00090-h