Nitriding Process Characterization of Cold Worked AISI 304 and 316 Austenitic Stainless Steels

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Regression analysis of shot peening process for performance characteristics of AISI 304 austenitic stainless steel

The surface fibers of the material are yielded in tension by the impact of shots in shot peening process. Below the surface fiber an even thin skin surface layer of material is deformed and this layer is highly stressed in compression. It results in the improvement of surface and mechanical properties of the material. Regression analysis is the statistical modeling technique, and it is suitable...

متن کامل

Mechanical Characterization of Friction Welded AISI 304 Steels

There are many industries where austenitic stainless steel needs to be welded specially in power generation industries. Unfortunately the austenitic stainless welding has several fabrication and metallurgical drawbacks when welded by using conventional fusion welding methods, which can often leads to in-service failure. The most pronounced fabrication faults are hot cracks due to inadvertent us...

متن کامل

Surface Texturing-Plasma Nitriding Duplex Treatment for Improving Tribological Performance of AISI 316 Stainless Steel

Surface texturing-plasma nitriding duplex treatment was conducted on AISI 316 stainless steel to improve its tribological performance. Tribological behaviors of ground 316 substrates, plasma-nitrided 316 (PN-316), surface-textured 316 (ST-316), and duplex-treated 316 (DT-316) in air and under grease lubrication were investigated using a pin-on-disc rotary tribometer against counterparts of high...

متن کامل

Microstructure and Mechanical Properties of Cold Rolled AISI 304L and 316L Austenitic Stainless Steels during Reversion Annealing

Microstructural evolutions during annealing of cold rolled AISI 304L and AISI 316L stainless steels were studied. Cold rolled AISI 304L alloy was fully martensitic but cold rolled AISI 316L alloy was partially martensitic due to the higher stability of the austenite phase in the latter. During continuous heating to elevated temperatures, the complete reversion of strain-induced martensite at 75...

متن کامل

Design optimization of cutting parameters for turning of AISI 304 austenitic stainless steel using Taguchi method

In the present work Taguchi method is used to optimize cutting parameters during dry turning of AISI 304 austenitic stainless steel with AlTiCrN coated tool. The coating was deposited on fine-grained K-grade (ISO K-20) cemented carbide cutting insert using physical vapor deposition (PVD) technique. The turning parameters evaluated are cutting speed of 200 and 260 m/min, feed rate of 0.20 and 0....

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of Metallurgy

سال: 2017

ISSN: 1687-9465,1687-9473

DOI: 10.1155/2017/1052706