New Pinhole Test Method for Galvanized Sheet Steel
نویسندگان
چکیده
منابع مشابه
Corrosion of Galvanized Steel in Soils
The results of measurements of the corrosion of galvanized steel and of bare steel and zinc as reference materials after exposure to different soil conditions for a maximum of 13 years are reported. The magnitude and progress of corrosion of galvanized steel as determined by weight loss and pitting is interpreted in terms of the environmental conditions to which the specimens were exposed. From...
متن کاملStudies on defects in galvanized coating on steel wire
Causes for deposition of defective galvanized coating (lumpy deposition of coating during hot dip galvanizing) of carbon-steel wire have been investigated. It is established that the lumpy deposition is caused due to segregation of silicon on the surface of steel wire. Due to this change in composition of the steel at surface, the regions get modified and lie in Sandelin hyper reactive zone. Th...
متن کاملThe way forward in passivation of galvanized steel coils
Within the Fives Group, Fives Stein, Fives DMS and Fives Bronx design and supply a wide range of production, transformation and treatment lines for carbon, stainless and silicon steel. From pickling and annealing lines to the continuous galvanizing line, from rolling mills to tube and pipe mills, our teams will offer you their expertise and the best available technologies to achieve the highest...
متن کاملA new way to evaluate steel sheet surfaces
This paper introduces a new assessment technique to monitor the quality of coated steel sheet surfaces, mainly used in the construction industry, e.g. as cladding for commercial buildings, external surface composite panels or even domestic applications, so clearly the visual appearance is critical. Normally, these types of steel sheets are coil coated onto steel strips. After curing the coating...
متن کاملJoining of Cold-Reduced Carbon Steel Sheet and Aluminum Sheet by Impulsive Riveting Method and Punch Riveting Method
The impulsive riveting method is described as the punching and joining of sheet metal carried out using the impulsive energy of a weight accelerated by an air compressor. Parts are held together between the rivet and rivet-holder. A hole is made in the sheets by the high speed collision of rivet and a weight (approximately 100 m/s or more). Another method, punch riveting, joins the sheets by pr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Metal Finishing Society of Japan
سال: 1972
ISSN: 1884-3395,0026-0614
DOI: 10.4139/sfj1950.23.142