New Developments in Chemical Wet Processes. Microfabrication Based on Self-assembled Monolayer Resists and Wet-chemical Processes.
نویسندگان
چکیده
منابع مشابه
Influence of citric acid on SnO2 nanoparticles synthesized by wet chemical processes.
Tin oxide (SnO2) nanoparticles with size range of 19 to 100 nm were successfully synthesized using wet chemical process (i.e., chemical precipitation and sol-gel processes). The samples were analysed by X-Ray diffraction, Scanning electron microscopy, Energy dispersive X-ray spectroscopy, Raman and FTIR spectroscopy, BET surface area and Thermogravimetric analyses. The results showed that varia...
متن کاملWet chemical functionalization of graphene.
The fullerenes, carbon nanotubes, and graphene have enriched the family of carbon allotropes over the last few decades. Synthetic carbon allotropes (SCAs) have attracted chemists, physicists, and materials scientists because of the sheer multitude of their aesthetically pleasing structures and, more so, because of their outstanding and often unprecedented properties. They consist of fully conju...
متن کاملWet chemical synthesis and physical characterization of doped CeO2 nanoparticles
Solid electrolytes based on doped cerium oxide, Ce(M)O2-δ (M = rare-earth cations), are of considerable interest for potential use in low temperature solid oxide fuel cells (LTSOFCs) due to its higher ionic conductivity than YSZ based solid electrolyte. In this research work, crystalline, pure Ce1-xMxO2-δ (where M = Gd or Sm, x = 0.10 or 0.20) based nanoparticles were prepared by chemical prec...
متن کاملWet-Chemical Etching and Cleaning of Silicon
A Introduction Research and manufacturing related to silicon devices, circuits, and systems often relies on the wet-chemical etching of silicon wafers. The dissolution of silicon using liquid solutions is needed for deep etching and micromachining, shaping, and cleaning. Also, wet-chemistries are often used for defect delineation in single crystal silicon materials. In this paper, a review of t...
متن کاملA self-assembled monolayer-assisted surface microfabrication and release technique
This paper describes a method of thin film and MEMS processing which uses self-assembled monolayers as ultra-thin organic surface coating to enable a simple removal of microfabricated devices off the surface without wet chemical etching. A 1.5-nm thick self-assembled monolayer of dodecyltrichlorosilane reduces the adhesion between the SiO substrate surface 2 and a 100-nm thick evaporated alumin...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Hyomen Kagaku
سال: 2001
ISSN: 0388-5321,1881-4743
DOI: 10.1380/jsssj.22.364