Neural Network Based Simulation of Micro Creeping Fibrous Composites SiC/Al6061 for Plastic Behaviour

نویسندگان

چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

A METAHEURISTIC-BASED ARTIFICIAL NEURAL NETWORK FOR PLASTIC LIMIT ANALYSIS OF FRAMES

Despite the advantages of the plastic limit analysis of structures, this robust method suffers from some drawbacks such as intense computational cost. Through two recent decades, metaheuristic algorithms have improved the performance of plastic limit analysis, especially in structural problems. Additionally, graph theoretical algorithms have decreased the computational time of the process impre...

متن کامل

A Novel Method to Decrease Micro-residual Stresses of Fibrous Composites by Adding Carbon Nanotube

In this research, a novel method to decrease micro-residual stresses of fibrous composites by adding carbon nanotubes (CNTs) is proposed in detail. The negative coefficient of thermal expansion and the high young’s modulus of CNTs can be utilized to counterbalance the process induced residual stresses in composites. To this end, first, the effects of adding CNTs to the matrix of fibrous composi...

متن کامل

The plastic behaviour of silicon subjected to micro-indentation

Micro-indentation is widely used in evaluating the mechanical properties of ceramics. It is also an important measure in the study of machinability of brittle materials. Because of the complexity of interaction in the vicinity of the contact zone between the indenter and work material, an analytical or experimental method is unable to predict the detailed evolution process of deformation. With ...

متن کامل

Neural Network Based Vision System for Micro Workpieces Manufacturing

A neural network based vision system for micro workpieces manufacturing is developing. The system has to recognize the shapes of the micro workpieces and to give the information for correction of the workpieces manufacturing process. The system prototype was proved off-line on the task of 3 mm screw shape recognition. The shape distortions were made with the incorrect position of the cutter in ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of Theoretical and Applied Mechanics

سال: 2017

ISSN: 1314-8710,0861-6663

DOI: 10.1515/jtam-2017-0003