Nanostructuring of Titanium by Anodic Oxidation with Sulfuric and Hydrofluoric Acid
نویسندگان
چکیده
منابع مشابه
Titanium oxide nanotube arrays prepared by anodic oxidation
Titanium oxide nanotubes were fabricated by anodic oxidation of a pure titanium sheet in an aqueous solution containing 0.5 to 3.5 wt% hydrofluoric acid. These tubes are well aligned and organized into high-density uniform arrays. While the tops of the tubes are open, the bottoms of the tubes are closed, forming a barrier layer structure similar to that of porous alumina. The average tube diame...
متن کاملSurface Characterization of Titanium Implants Treated in Hydrofluoric Acid
The results of XPS measurements of commercially pure titanium (cp-Ti) before and after chemical treatment are presented. We have measured XPS spectra of core levels (Ti 2p, O 1s, C 1s, F 1s) and valence bands of coarse-grained cp-Ti before and after standard acid treatment accepted in dentistry (in 1% HF and 40% HF for 1 min). It is found, that acid treatment of cp-Ti reduces the content of hyd...
متن کاملThe effect of sulfuric acid on pore initiation in anodic alumina formed in oxalic acid
In this work, a tracer study on pore initiation in anodic alumina in oxalic acid was performed. Effects of some experimental parameters such as applied electrical potential, electrolyte composition and heat pretreatment were evaluated. Electrochemical and morphological experiments were performed using potentiostatic anodizing and scanning electron microscopy (SEM) techniques, respectively. Effe...
متن کاملOsteogenic activity of titanium surfaces with hierarchical micro-/nano-structures obtained by hydrofluoric acid treatment
An easier method for constructing the hierarchical micro-/nano-structures on the surface of dental implants in the clinic is needed. In this study, three different titanium surfaces with microscale grooves (width 0.5-1, 1-1.5, and 1.5-2 μm) and nanoscale nanoparticles (diameter 20-30, 30-50, and 50-100 nm, respectively) were obtained by treatment with different concentrations of hydrofluoric ac...
متن کاملEtching with Hydrofluoric Acid
Photoresists, wafers, plating solutions, etchants and solvents ... Phone: +49 731 977343 0 www.microchemicals.eu [email protected] Etching of SiO2, Quartz, and Glasses with HF Hydrofluoric acid is the only etchant which attacks amorphous SiO2, quartz, or glasses at significant high etch rate. However, HF is not only a strong corrosive, but also highly toxic towards higher concentrations: ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Current Directions in Biomedical Engineering
سال: 2018
ISSN: 2364-5504
DOI: 10.1515/cdbme-2018-0154