Nanocrystallization of Coarse Primary Phases in Al- and Mg-Based Alloys Induced by HCPEB Treatment
نویسندگان
چکیده
منابع مشابه
Deformation-induced nanocrystallization: A comparison of two amorphous Al-based alloys
Using conventional and high-resolution transmission electron microscopy (HRTEM), the effects of rolling at room temperature on the microstructures of amorphous Al90Fe5Gd5 and Al86.8Ni3.7Y9.5 were compared. In rolled Al90Fe5Gd5, nanocrystallites were observed at shear bands, whereas none were observed in rolled Al86.8Ni3.7Y9.5. When HRTEM was combined with with Fourier transform filtering, nanos...
متن کاملMelt Protection of Mg-Al Based Alloys
This paper reports the current status of Mg melt protection in view to identify near-future challenges, but also opportunities, for Mg melt protection of Mg-Al based alloys. The goal is to design and manufacture sustainable Mg alloys for resource efficiency, recycling and minimising waste. Among alternative cover gas technologies for Mg melt protection other than SF6: commercially available tec...
متن کاملSurface alloying of Mg alloys after surface nanocrystallization.
Surface nanocrystallization using a surface mechanical attrition treatment effectively activates the surface of magnesium alloys due to the increase in grain boundary diffusion channels. As a result, the temperature of subsequent surface alloying treatment of pure Mg and AZ91 alloy can be reduced from 430 degrees C to 380 degrees C. Thus, it is possible to combine the surface alloying process w...
متن کاملPrecipitates and intermetallic phases in precipitation hardening Al–Cu–Mg–(Li) based alloys
The present study contains a critical review of work on the formation of precipitates and intermetallic phases in dilute precipitation hardening Al–Cu–Mg based alloys with and without Li additions. Although many suggestions for the existence of pre-precipitates in Al–Cu–Mg alloys with a Cu/Mg atomic ratio close to 1 have been made, a critical review reveals that evidence exists for only two tru...
متن کاملDeformation-driven catalysis of nanocrystallization in amorphous Al alloys
Nanocrystals develop in amorphous alloys usually during annealing treatments with growth- or nucleation-controlled mechanisms. An alternative processing route is intense deformation and nanocrystals have been shown to develop in shear bands during the deformation process. Some controversy surrounded the idea of adiabatic heating in shear bands during their genesis, but specific experiments have...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Nanomaterials
سال: 2013
ISSN: 1687-4110,1687-4129
DOI: 10.1155/2013/815384